User manual FRIGIDAIRE FEB30S5ASB Data Sheet

[. . . ] · All safety grounds (both internal and external) are correctly and securely reassembled. · All panels are properly and securely reassembled. 1 CONVECTION ELECTRONIC OVEN CONTROL In models containing a convection oven, the electronic oven control is mounted as follows: 1. A relay is mounted beside the control which operates the convection fan in some models. [. . . ] Then the oven will operate in the normal bake mode. NORMAL BAKE MODE During a normal bake mode, the oven uses the broil element by cycling the broil element for given periods of time (7 sec/min). After this time, the broil element is shut off, and the bake element is on the remainder of the minute. Both elements use full power when they are on, but they are never on at the same time. 1 BROIL 2 BAKE BAKE 2 FAN BLADE 1 = Broil 7 sec/min 2 = Bake 52 sec/min The fan blade is mounted in the rear of the oven and has a "D" shaped mounting hole. Only minimum clearance exists between the oven back, fan blade, and fan shroud. Access to the fan blade is gained by removing the fan shroud, held in place by three screws, from the inside of the oven. The fan blade is held in place with a hex nut that has left handed threads. When removing this nut, gently hold the fan blade, and turn the nut clockwise. If one of the blades becomes deformed, it may be bent back into shape using a flat surface as a reference. A flat washer is located on the motor shaft between the snap ring on the shaft and the fan blade. NOTE: IF THE FAN BLADE IS BENT AND MOTOR VIBRATIONS INCREASE, THE NOISE MADE BY THE FAN WILL BE GREATER. 4 FAN RELAY The fan motor runs continuously while in the convection mode unless the door is opened. If the fan does not operate, check the following: · · · · · Display illuminated on the electronic control. 240 Volts available at fan motor when convection relay is closed and door is closed. Voltage input to fan relay coil during convection bake with door closed. Door/light switch. FAULT CODES F1 - An error has been detected in the control circuit. [. . . ] BAKE/ROAST or PREHEAT pad and set the oven temperature to 500°F/260°C or more using the UP or DOWN arrow pad. A beep sounds and a number appears in red to the right of the display. Push the UP or DOWN arrow pad to change °F to °C or °C to °F in the display. [. . . ]