User manual FRIGIDAIRE FFEF3011LW SERVICE DATA SHEET
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual FRIGIDAIRE FFEF3011LW. We hope that this FRIGIDAIRE FFEF3011LW user guide will be useful to you.
Manual abstract: user guide FRIGIDAIRE FFEF3011LWSERVICE DATA SHEET
Detailed instructions for use are in the User's Guide.
[. . . ] SERVICE DATA SHEET
Electric Ranges with ES 100/105 Electronic Oven Control
Electronic Oven Control (E. O. C. rear view)
- This service data sheet is intended for use by persons having electrical and mechanical training and a level of knowledge of these subjects generally considered acceptable in the appliance repair trade. [. . . ] You may increase the oven temperature in 5°F increments with each press of the UP ARROW key pad. You may also adjust the oven temperature downward in 5°F increments with each press of the DOWN ARROW key pad (total adjustment range is +35°F to -35° F). To accept the change, wait until the oven control provides the acceptance beep (See Notes below). The oven temperature adjustment has been accepted by the oven control and the display will return to the time of day.
2.
3. 4.
Notes:
·
If at any time during the process of adjusting the oven temperature feature you decide not to make the change, press the Stop, Clear Off or Cancel key pad once before the acceptance beep. The oven temperature adjustment feature can not be modified if Bake or Broil is active. The oven temperature adjustment may be made if your oven control has been set for °C (Celsius) temperature display mode. In this case each press of the UP ARROW or DOWN ARROW key pad will adjust in 1°C increments upward (maximum +18°C) or downward (maximum -18°C), depending on which arrow key pad is pressed.
Electronic Oven Control Fault Code Descriptions (some models / models that display F1 or F3)
Note: Only two fault codes are displayed by this control - F1 or F3. Generally, F1 display implies the electronic oven control itself has detected an internal malfunction. In either case, an alarm will accompany a displayed F1 or F3.
4.
· ·
Fault Code
F1
Likely Failure Condition/Cause
1. [. . . ] Severe overheating may require the entire oven to be replaced should damage be extensive. (F11 & 13) If fault returns upon power-up, replace EOC.
Resistance Temperature Detector Circuit Analysis Matrix
IMPORTANT
DO NOT REMOVE THIS BAG OR DESTROY THE CONTENTS
WIRING DIAGRAMS AND SERVICE INFORMATION ENCLOSED
REPLACE CONTENTS IN BAG
p/n 316441457 Rev A (1001)
General Troubleshooting Diagram
General Troubleshooting Schematic [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE FRIGIDAIRE FFEF3011LW
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual FRIGIDAIRE FFEF3011LW will begin.