User manual FRIGIDAIRE FFID2426TS

[. . . ] You will need additional parts listed above to complete your installation. Flush water line prior to making the final connection to prevent clogging of dishwasher's filter screen. The dishwasher will look, sound, and perform best when properly leveled. (NOTE: If levelers are removed during installation, make sure the floor is flat and free of any obstruction. [. . . ] The drain hose will be routed from dishwasher to air gap inlet as shown in Figure 6. NOTE: If the drain hose is installed through the floor, an air gap is necessary. The knock out plug must be removed from inside disposer inlet before making the final fit to drain hose. Before cutting drain hose access, check both sides of selected area to avoid interference. If the cabinet wall is wood, sand edges of hole until smooth and rounded. If cabinet wall is metal, cover all sharp edges with electrical or duct tape to avoid cutting drain hose. drying Vent Hose (if equipped) Care must be given during installation and removal of the dishwasher to avoid disconnection of the vent hose that is attached to the top of the dishwasher. If levelers have to be removed, make sure floor is free of obstructions. Place dishwasher inside cabinet area so that it is centered in opening. Use caution when moving dishwasher to prevent damage to dishwasher, floor, and cabinets. Remove lower rack to check that dishwasher is level from side to side by placing a level on the bottom of the inner door. Remove lower rack to check that dishwasher is level from front To back by placing the level at the bottom of the tub at the lower Plumbing material and drain hose must not come in contact with wiring or electrical components. Failure to follow this warning could result in personal injury from exposed wiring. Pull out unit and check to see if drain hose is correctly attached to the drain pump assembly. If drain hose is not attached to drain pump, follow the instruction sheet (included with drain hose) on how to correctly install the drain hose to the drain pump assembly. IMPORTANT: Make sure there are no sharp bends or kinks that might restrict drain flow. IMPORTANT: Be careful not to overtighten clamp or you may damage end of hose. Do not connect hose to horizontal pipe between sink drain and disposer. The drain hose loop must be at least 32" high from the floor to insure proper drainage. Property Damage Do not solder within 6" of the water inlet valve. Be sure the dishwasher is placed where the water inlet valve will be kept from freezing. Flush water line before connecting it to water inlet valve to prevent early clogging of filter screen. [. . . ] Screw mounting brackets firmly to countertop using screws provided in literature packet. If door hits mounting brackets lower the dishwasher in front and rear. Note: Open and close door to make sure it does not hit surrounding cabinets or countertop. Using a Phillips head screw driver, remove two (2) screws from inner door. [. . . ]