User manual FRIGIDAIRE FGGF3031KW SERVICE DATASHEET

[. . . ] Within 5 seconds of setting 550°F, press and hold the bake pad for approximately 15 seconds until a single beep is heard (longer may cause F11 shorted keypad alarm). Use the slew keys to adjust the oven temperature up or down 35°F in 5°F increments. [. . . ] Press & hold the oven light keypad until one beep is heard (after 3 seconds). The Cooktop Locked indicator light will turn OFF and the gas surface burners may be used normally. Press & hold the oven light keypad until one beep is heard (after 3 seconds). The Cooktop Locked indicator light will turn ON and the gas surface burners and functions are locked out until the cooktop is unlocked. Fault Code F10 F11 F12 F13 F30 F31 Likely Failure Condition/Cause Runaway Temperature. If oven continues to overheat when the power is reapplied, replace EOC. Severe overheating may require the entire oven to be replaced should damage be extensive. (F11, 12 & 13) Disconnect power, wait 30 seconds and reapply power. (F11, 12 & 13) If fault returns upon power-up, replace EOC. 4. 1. (F30 or F31) Check resistance at room temperature & compare to RTD Sensor resistance chart. (F30 or F31) Check resistance at room temperature, if less than 500 ohms, replace RTD Sensor Probe. [. . . ] If contacts are open when motor cam depresses switch, replace Lock Motor Assembly. (F90, 91, 92, 93 & 94) Check for binding of the Latch Cam, Lock Motor Rod & Lock Motor Cam. [. . . ]