User manual FRIGIDAIRE FGX831FS2 INSTALLATION

[. . . ] This symbol alerts you to hazards that can kill or hurt you or others. All safety messages will be preceded by the safety alert symbol and the word "DANGER" or "WARNING". DANGER You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. [. . . ] The more the dryer is used, the more often you should check the exhaust system and vent hood for proper operation. The maximum length of the exhaust system depends upon the type of duct used, number of elbows and type of exhaust hood. Do not exhaust dryer into a chimney, a wall, a ceiling, an attic, a crawl space or any concealed space of a building. If the dryer is not exhausted outdoors, some fine lint will be expelled into the laundry area. An accumulation of lint in any area of the home can create a health and fire hazard. Regularly inspect the outdoor exhaust opening and remove any accumulation of lint around the outdoor exhaust opening and in the surrounding area. The laundry center may be exhausted four (4) ways with rear flush installation: 1. 43 cm) away from the wall (flush to wall exhausting may be done by going below the dryer then sideways). An exhaust hood positioned to line up with the dryer exhaust can be installed directly through the outside wall. Installation MUST conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223. If codes allow, flexible metal tubing may be used to connect your dryer to the gas supply line. The dryer and its individual shutoff valve MUST be disconnected from the gas supply piping system during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3. The dryer MUST be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3. A laundry center installed in a bedroom, bathroom, recess or closet, MUST be exhausted outdoors. No other fuel burning appliance shall be installed in the same closet as the Gas laundry center. 2 square cm) of opening, equally divided at the top and bottom of the door, is required. Air openings are required to be unobstructed when a door is installed. The following illustrations show minimum clearance dimensions and air openings for proper operation in a recess or closet installation. Dryer MUST be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. If dryer is exhausted through the floor and area beneath the mobile home is enclosed, the exhaust system MUST terminate outside the enclosure with the termination securely fastened to the mobile home structure. When installing a gas dryer into a mobile home, a provision must be made for outside make up air. This provision is to be not less than twice the area of the dryer exhaust outlet. [. . . ] Gently set the laundry center back down to allow the rear legs to self adjust. Screw the front leveling legs up or down to ensure the laundry center is resting solid on all four legs (no rocking of the laundry center should exist). Remove the two (2) screws securing the dryer front access panel to the dryer cabinet. Semi-rigid or approved pipe from the gas supply line to the 3/8 inch (0. [. . . ]