User manual FRIGIDAIRE FNDP15W INSTALLATION

[. . . ] If locking nuts are not removed on units with metal feet, mounting holes in appliance will not align to mounting holes in brackets. Repeat leveling and rocking until all four (4) feet are sturdy on the floor and pedestal is level. Without turning the rubber foot, lock each pedestal leg in place by tightening its lock nut tight against the pedestal base. [. . . ] Still tipped, slide the dryer back against the rear brackets and gently set down the front so the appliance is between the front and rear brackets. Use the following instructions for mounting any of these types of dryers to the pedestal: Adjust the appliance side-to-side to align its mounting holes with the pedestal's bracket holes. Install 2 screws through each rear bracket into the base of the dryer. Install a screw through each front bracket into the base of the dryer. Insert "A" tab of each rear bracket into the rear slots on rear of pedestal using rear bracket spacers. Install 2 screws through each rear bracket into aligning pedestal holes. Use the following instructions for mounting any of these types of dryers to the pedestal: - EXCESSIVE WEIGHT HAZARD - To avoid back or other injury, have more than one person move or lift the dryer. Using two or more persons, slightly tip the dryer back and lift it onto the pedestal. Still tipped, slide the dryer back against the rear brackets so tabs on rear brackets engage the slots on the back of the dryer. Gently set down the front so the appliance is between the front and rear brackets. Adjust the appliance side-to-side to align its mounting holes with the pedestal's bracket holes. Install a screw through each front bracket into the base of the dryer. Insert "B" tab of each rear bracket into the front slots on rear of pedestal. Install 2 screws through each rear bracket into aligning pedestal holes. Use the following instructions for mounting this type of washer to the pedestal: - EXCESSIVE WEIGHT HAZARD - To avoid back or other injury, have more than one person move or lift the washer. Using two or more persons, slightly tip the washer back and lift it onto the pedestal. Still tipped, slide the washer back against the rear brackets and gently set down the front so the appliance is between the front and rear brackets. Adjust the appliance side-to-side to align its mounting holes with the pedestal's bracket holes. [. . . ] Install a screw through the inner hole of each front bracket into the base of the dryer. Insert "B" tab of each rear bracket into the front slots on rear of pedestal. Install 2 screws through each rear bracket into aligning pedestal holes. [. . . ]