User manual FRIGIDAIRE FPBM189KF INSTALLATION

[. . . ] To find the location of the studs, one of the following methods may be used: A. Use a stud finder, a magnetic device which locates the nails in the stud. Use a hammer to tap lightly across the mounting surface to find a solid sound. The center of the stud can be located by probing the wall with a small nail to find the edges of the stud and then placing a mark halfway between the edges. [. . . ] MAXIMUM DUCT LENGTH: For satisfactory air movement, the total duct length of 3 1/4" x 10" rectangular or 6" diameter round duct should not exceed 140 feet. Present additional resistance to air flow and are equivalent to a section of straight duct which is longer than their actual physical size. When calculating the total length, add the equivalent lengths of all transitions and adapters plus the length of all straight duct sections. Figure 3 shows the approximate feet of equivalent length of some typical ductwork parts. Use the values in parentheses for calculating air flow resistance equivalent, which should total less than 140 feet. Open the bottom of the carton, bend the carton flaps back and tilt the oven over to rest on plastic foam pad. Lift carton off oven and remove all packing materials, Installation Instructions, Wall Template, Top Template, Turntable and Turntable Support; however, DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the ceiling in the oven cavity. Check the oven for any damage, such as misaligned or bent door, damaged door seals and sealing surfaces, broken or loose door hinges and latches and dents inside the cavity or on the door. If there is any damage, do not operate the oven and contact your dealer or Electrolux AUTHORIZED SERVICER. 1 1/2" Wood Bit or Metal Hole Cutter (if metal cabinet is used) Saw to cut exhaust opening (if needed) Protective Drop Cloth for product and range you may also use carton for protection Scissors Pencil Measure Tape The INSTALLATION HARDWARE items - are in a small bag. This Over the Range Microwave Oven is designed for adaptation to three types of hood ventilation systems. Recirculating requires the use of the Charcoal Filters, which have already been installed in the oven. Remove 3 screws from back edge and 5 screws from the top of Fan Cover Bracket. Save 3 screws to use them to attach Exhaust Damper Assembly to the wall later and discard remaining 5. Rotate the Hood Fan Unit 180° so that the Fan Blade Openings are facing the back of the oven. Use 1 Tapping Screw 4 x 8 mm from the INSTALLATION HARDWARE and tighten into place. This assembly will be mounted to the Outside Rear Exhaust cutout in future instructions. The Charcoal Filters should be replaced every 6 to 12 months, depending on use. Remove and save 3 screws from back edge and 5 screws from the top of the Fan Cover Bracket to use at Step 5. Rotate the Hood Fan Unit 180° so that the Fan Blade Openings are facing the back of the oven. Then rotate the Hood Fan Unit 90° so that the Fan Blade Openings are facing the top of the oven. Be careful not to pinch the lead wire between the inner bracket and the Hood Fan Unit. [. . . ] Install the oven by tilting it forward and sliding it onto two tabs of the Mounting Plate. Use the two Top Cabinet Screws and two Flat Washers, supplied in the INSTALLATION HARDWARE, to attach the unit to the top cabinet. Secure the bottom of the oven to the Mounting Plate by using two Tapping Screws 4 x 8 mm from the INSTALLATION HARDWARE. (For Vertical Exhaust Only) Attach the Exhaust Damper Assembly to the fan Cover Bracket on the top of the outercase cabinet by sliding it into the slits in the same direction as the allow using screw (A) which removed at (C) VERTICAL EXHAUST STEP 1 on page 5. [. . . ]