User manual FRIGIDAIRE FPF523TCW

[. . . ] TOOLS NEEDED Flat-blade and Phillips screwdrivers Level Tape measure Through-the-wall Installation: In addition to the tools listed above, the following tools are needed for through-the-wall installation. TOOLS NEEDED saw caulk Parts Supplied: Check that all parts are included in parts package: Hardware pan - head Phillips screws round - head screws pan - head Phillips screws Qty. Hardware Top channel Window sash seal Qty. 3 1 1 1 1 2 Foam seal window lock bracket side curtains 2 Safety Lock (for Vinyl-Clad window) weather seals 1 Installation Instructions NOTE: available from your dealer or service center. [. . . ] See "Accessories. " Do not use any screws other than those specified here. Location Requirements: IMPORTANT:Observe all governing codes and ordinances. Grounded electrical outlet within 4 ft (122 cm) of where the power cord exits the air conditioner. Air conditioner weights between 70 and 85 Ibs (32 to 40 kgs). NOTE: Do not use an extension cord. Air must be able to pass freely through the cabinet louvers. (FIG. 1) Window Installation: Window opening measurements (FIG. 2) : FIG. 1 A FIG. 2 A. Cabinet louvers Remove packaging material: Remove and dispose of / recycle packaging materials. Remove tape and glue residue from surfaces before installing the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your fingers. A: For wooden window: B: For Vinyl-Clad window: FIG. 11 FIG. 12 FIG. 13 C 1. Drill holes and drive locking screws: A: For wooden windows: screws through the holes in the side curtains into the window C B: For Vinyl-Clad windows: screw screw 3. Trim the weather seal 4 Installation Instructions FIG. 15 Complete Installation: 1. Insert window sash seal behind the top of the lower window sash and against the glass of the upper window (FIG. 15). Place the window-lock bracket on top of lower window and against upper window sash on right side of the window (FIG. 15). Insert front tabs of front panel into top of cabinet and swing front into place (FIG. 17A). Window sash seal screws electronics plug Through-the-Wall Cabinet Installation: Option 1--wood, metal or plastic molding: When using a wood, metal or plastic molding, the wood frame should line up with the inside wall as shown FIG. 18. Option 2--Plastered wall with no molding: into the inside wall FIG. 19. [. . . ] Window sash seal screws electronics plug Through-the-Wall Cabinet Installation: Option 1--wood, metal or plastic molding: When using a wood, metal or plastic molding, the wood frame should line up with the inside wall as shown FIG. 18. Option 2--Plastered wall with no molding: into the inside wall FIG. 19. Measure the outside width and height of frame to determine wall opening dimensions. Attach frame securely to the wall. 5 Installation Instructions FIG. 21 A NOTE: Dimension for depth depends on wall thickness and type of molding (FIG. 21). [. . . ]