User manual FRIGIDAIRE FPIF3093LF SERVICE DATASHEET

[. . . ] SERVICE DATA SHEET Electric Range with ES 540 Electronic Oven Control NOTICE - This service data sheet is intended for use by persons having electrical and mechanical training and a level of knowledge of these subjects generally considered acceptable in the appliance repair trade. The manufacturer cannot be responsible, nor assume any liability for injury or damage of any kind arising from the use of this data sheet. SAFE SERVICING PRACTICES To avoid the possibility of personal injury and/or property damage, it is important that safe servicing practices be observed. [. . . ] If fault code is present with cold oven test oven temperature sensor probe circuit resistance. If temperature sensor probe circuit is good but fault code remains when oven is cold replace the EOC. If oven is severely overheating/heating when no cook cycle is programmed test oven temperature sensor probe circuit resistance using the RTD scale found in the service tech sheet. Also verify that the temperature sensor probe in properly installed in the oven cavity. If oven continues to heat when the power is reapplied, replace the EOC. NOTE: Severe overheating may require the entire oven to be replaced should damage be extensive. Reset power supply to range - Disconnect power, wait 30 seconds and reapply power. If keyboard ciruits check good replace the EOC. F11 Shorted keypad or selector switch. 4. F12 F13 F14 EOC Internal software error or failure. Membrane switch tail missing or not connected Communication failure between EOC & ESEC system Open oven sensor probe circuit. Door lock motor or latch circuit failure. Disconnect power, wait 30 seconds and reapply power. Check/reseat connections between membrane switch, display boards and EOC. (F30) Check resistance at room temperature & compare to RTD Sensor resistance chart. (F31) Check resistance at room temperature, if less than 500 ohms, replace RTD Sensor Probe. Check for shorted Sensor Probe harness between EOC & Probe connector. [. . . ] Press the Self Clean keypad to change the sign of the adjustment to a (-) if necessary. Once the desired adjustment (-35° to 35° F) has been entered, press the Start keypad to accept the change or the Cancel keypad to reject the change. The adjustments made will not change the self-cleaning temperature. F20 F30 F31 F90 F91 F92 F93 F94 F95 Electronic Oven Control & Jumper Connections (EOC Rear View) Circuit Analysis Matrix Resistance Temperature Detector (RTD) Resistance Temperature Detector Scale RTD SCALE Temperature (°F) 32 ± 1. 9 Resistance (ohms) 1000 ± 4. 0 1091 ± 5. 3 1453 ± 8. 9 1654 ± 10. 8 1852 ± 13. 5 2047 ± 15. 8 2237 ± 18. 5 2697 ± 24. 4 IMPORTANT DO NOT REMOVE THIS BAG OR DESTROY THE CONTENTS WIRING DIAGRAMS AND SERVICE INFORMATION ENCLOSED 75 ± 2. 5 250 ± 4. 4 350 ± 5. 4 450 ± 6. 9 550 ± 8. 2 650 ± 9. 6 900 ± 13. 6 REPLACE CONTENTS IN BAG p/n 316904436 (1007) General Troubleshooting Diagram General Troubleshooting Schematic [. . . ]