User manual FRIGIDAIRE FRA073PU1

[. . . ] All about the Use &Care of your Portable Air Conditioner TA B L E O F C O N T E N T S Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3 Product Registration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Unit Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-11 Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 18 7 Air Conditioner Features Air Conditioner Features CONTROL PANEL DISPLAYS TEMPERATURE/TIME TURNS UNIT ON OR OFF SWING BUTTON SLEEP MODE SETS MODE ADJUSTS TEMPERATURE OR TIME SETS FAN SPEED CHECK FILTER RESET BUTTON ACTIVATES TIMER Fig. 21 REMOTE CONTROL MODE INDICATION FAN SPEED SELECTION TEMPERATURE/TIMER CONTROL BUTTONS MODE SELECTOR SLEEP BUTTON FAN SPEED SELECTOR TIMER BUTTONS SWING BUTTON ON/OFF BUTTON RESET + LOCK PIN BUTTONS Fig. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickelcadmium) batteries. In this mode there is no need to use the exhaust hose or drainage hose. However, if you require stale or smokey air to be removed from the room, hook up the duct accessories as described in the "EXHAUSTING HOT AIR" section. The fan will run at the selected speed and the display will show the room temperature. You can set both delay stop and delay start while unit is in ON position or OFF position. When unit is in ON position, first press TIMER button to go to delay stop setting, then "timer off" light will illuminate, tap or hold the UP arrow ( ) or the DOWN arrow ( ) to change delay stop timer at 0. 5 hour increments up to 10 hours, then at 1 hour increments up to 24 hours. Then press the TIMER button to confirm the setting (the control will confirm the setting automatically after 5 seconds) and go to delay start setting. If you don't need to set delay start, press the TIMER button again to exit. After 5 seconds, the control will automatically change the display back to previous temperature display. The delay start operation automatically selects mode, temperature and fan speed the same as last operation you set. When unit is in OFF position, press TIMER button will first go to delay start setting, then "timer on" light will illuminate, set the delay start and delay stop timing the same way as above. To cancel the timer setting, simply tap ( ) or ( ) button to change the timing to 0. 0. In this mode the selected temperature will increase by 2 °F 30 minutes after the mode is selected. The temperature will then increase by another 2 °F after an additional 30 minutes. This new temperature will be maintained for 7 hours before it returns to the originally selected temperature. This ends the "Sleep" mode and the unit will continue to operate as originally programmed. The "Sleep" mode program can be cancelled at any time during operation by again pressing the "Sleep" button. Note: This feature is unavailabe under FAN or DRY modes. All rights reserved. AUTO MODE: FAN MODE: TIMER OPERATION: SLEEP OPERATION: 2009 Electrolux Home Products, Inc. 9 Operating Instructions Operating Instructions (continued) SWING OPERATION: When you turn on the unit, the louver will swing and stop at a certain angle. Press the SWING button again while you want the louver stop at desired angle. This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. [. . . ] (this italic area appears inconsistent with the rest of the warranty where you indicate that you are responsible for repairing and replacing) Exclusions This warranty does not cover the following: 1. Products with original serial numbers that have been removed, altered or cannot be readily determined. Product that has been transferred from its original owner to another party or removed outside the USA or Canada. Products purchased "as-is" are not covered by this warranty. [. . . ]