User manual FRIGIDAIRE FRA09EPT1

[. . . ] All about the Use &Care of your Portable Air Conditioner TA B L E O F C O N T E N T S Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Unit Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-10 Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Before You Call . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] In this mode you do not need to use the exhaust adaptor hose, BUT the water collected must be discharged. The fan will run at low speed and the display will show the room temperature. When you set the air conditioner in AUTO mode, it will automatically select cooling, heating(inapplicable for cooling only models), or fan only operation depending on what temperature you have selected and the room temperature. The air conditioner will control room temperature automatically round the temperature point set by you. In this mode there is no need to use the exhaust hose or drainage hose. However, if you require stale or smokey air to be removed from the room, hook up the duct accessories as described in the "EXHAUSTING HOT AIR" section. The fan will run at the selected speed and the display will show the room temperature. You can set both delay stop and delay start while unit is in ON position or OFF position. To reset after cleaning the filter, press the "Filter" button and the light will go off. CHECK FILTER FEATURE: FAULT CODE: If the display reads "EA" , the room temperature sensor has failed. Contact your Authorized Frigidaire Service Center. If the display reads "ES" , the evaporator temperature sensor has failed. Contact your Authorized Frigidaire Service Center. If the display reads "E4" , the display panel communication has failed. Contact your Authorized Frigidaire Service Center. If the display reads "P1" , bottom tray is full. Carefully move the unit to a drain location, remove the bottom drain plug and let the water drain away. If error repeats, call for service. DRAINAGE: During dehumidifying mode, remove the supplied rubber stopper from the hose connector. Place the open end into a suitable drain, and make sure there are no kinks in the Continuous hose. 23 REMOTE CONTROL STORAGE : The door on side of the unit is for storing the remote, to open press it as shown in Fig. 24 2009 Electrolux Home Products, Inc. All rights reserved. 9 Operating Instructions, CARE & CLEANING Operating Instructions (continued) ADDITIONAL THINGS YOU SHOULD KNOW Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with. The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping. The control will maintain the set temperature within 2 °F, between 62 °F and 86 °F (17 °C and 30 °C). The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. To convert from one to the other and back, press and hold the "TEMP" Up ( ) and Down ( ) buttons together for 3 seconds. [. . . ] The consumer will be responsible for diagnostic costs and any removal, transportation and reinstallation costs which are required because of service, costs for labor, parts and transportation other than with respect to the Sealed Refrigeration System. Products with original serial numbers that have been removed, altered or cannot be readily determined. Product that has been transferred from its original owner to another party or removed outside the USA or Canada. Products purchased "as-is" are not covered by this warranty. [. . . ]