User manual FRIGIDAIRE FRA106CT10

[. . . ] All about the Use &Care of your Room Air Conditioner TA B L E O F C O N T E N T S Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Packaging . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Before You Call . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 2020211A1112 (June 2009) www. frigidaire. com USA 1-800-944-9044 www. frigidaire. ca Canada 1-800-265-8352 Important Safety Instructions NOTE: This USE & CARE MANUAL provides specific operating instructions for your model. [. . . ] After 5 seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Pressing the unit On/Off button at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either starts or stops. Once that happens the above steps have to be repeated again. CHECK FILTER FEATURE, YOU WILL SEE: Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. To reset after cleaning the filter, press the "Filter Reset" button and the light will go off. DO THIS: PRESS FILTER RESET BUTTON CLEAN AIR FEATURE(on some models): DO THIS: PRESS CLEAN AIR BUTTON 2009 Electrolux Home Products, Inc. Note: When this feature is "ON", the electronic air purifier is energized to remove pollen and impurities from the air. To cancel this feature, press the Clean Air button (the LIGHT will turn off). All rights reserved. 7 Operating Instructions Operating Instructions (continued) REMOTE SENSING FEATURE (on some models) LIGHT pulsing ( On & Off intermittently ). DO THIS: PRESS REMOTE SENSING START BUTTON NOTE: Unit display shows the set temperature NOTE: Remote display is actual temperature at remote control only Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode. To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button. Next, use the " " buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself ). 3) Figure 1 (VENT CLOSED) Figure 2 (FRESH AIR) Figure 3 (VENT OPEN) Air Directional Louvers AUGER WHEELS Air directional louvers control air flow direction. Your air conditioner has the louver type described below. Auger Type The louvers will allow you to direct the air flow Up or Down and Left or Right throughout the room as needed. Rotate the Auger Wheels until the desired Left/Right direction is obtained. Pivot horizontal louvers until the desired Up/Down direction is obtained. All rights reserved. (8-WAY) 2009 Electrolux Home Products, Inc. 9 Care and Cleaning & Energy Saving Ideas Care and Cleaning Clean your air conditioner occasionally to keep it looking new. Be sure to unplug the unit before cleaning to prevent shock or fire hazards. Air Filter Cleaning The air filter should be checked at least once a month to see if cleaning is necessary. Trapped particles in the filter can build up and cause an accumulation of frost on the cooling coils. Be sure filter is thoroughly dry before replacing Or instead of washing, you may vacuum the filter clean. NOTE: When replacing the air filter after cleaning, make sure the tabs on the air filter are on the upper part of filter, and placed outward as shown in the drawing on the left side. Tab Cabinet Cleaning Be sure to unplug the air conditioner to prevent shock or fire hazard. The cabinet and front may be dusted with an oil-free cloth or washed with a cloth dampened in a solution of warm water and mild liquid dishwashing detergent. Be sure to wring excess water from the cloth before wiping around the controls. [. . . ] The consumer will be responsible for diagnostic costs and any removal, transportation and reinstallation costs which are required because of service, costs for labor, parts and transportation other than with respect to the Sealed Refrigeration System. Products with original serial numbers that have been removed, altered or cannot be readily determined. Product that has been transferred from its original owner to another party or removed outside the USA or Canada. Products purchased "as-is" are not covered by this warranty. [. . . ]