User manual FRIGIDAIRE GLEFM397D Data Sheet

[. . . ] SERVICE DATA SHEET Electric Smoothtop Ranges with Electronic Surface Element Control (ESEC 10R) NOTICE - This service data sheet is intended for use by persons having electrical and mechanical training and a level of knowledge of these subjects generally considered acceptable in the appliance repair trade. The manufacturer cannot be responsible, nor assume any liability for injury or damage of any kind arising from the use of this data sheet. [. . . ] Contact technical line for further assistance. F5 02 UIB not communicating. ELECTRONIC SURFACE ELEMENT CONTROL (ESEC) - This range is equipped with an Electronic Surface Element Control (ESEC), which precisely controls the smoothtop cooking elements at multiple settings. For the user, the elements are operated in the same way as with conventional controls, by pushing in and turning the knob to the desired setting. The setting is shown in the digital display above the knob, instead of using graphics on the control panel. ESEC Hot Element Indicator ("HE") - While an element surface is hot, that element's display will show "HE". This is in place of the usual hot surface indicator light on ranges with conventional controls. ESEC Lockout Feature ( "- -" ) - The electronic oven control's Clean and Lock features will not operate when a surface element is ON. Conversely, the surface elements controlled by the ESEC will not operate when an oven control Clean or Lock mode is active. When the oven control is in a Clean or Lock mode, "- -" will appear in the ESEC displays to signify that the surface elements are locked out. NOTE: The "HE" (hot element) display will always have priority over the "- -" display. ESEC System Components - The ESEC system consists of a Power Board (main control board mounted on the mainback of the range) and User Interface Board or UIB (circuit boards with digital displays, mounted in the coontrol panel), four Potentiometers (push-to-turn control for each element) and the ESEC Harness that connects the boards and the oven control. [. . . ] Replacing the Power Board ­ When replacing the main control board (power board) on the back of the range, do not over-tighten the 2 screws that secure the Power Board. Over-tightening the screws can damage the plastic standoffs and possibly the board itself. REPLACE CONTENTS IN BAG P/N 316417609 (0407) ESEC SYSTEM DIAGRAM [. . . ]