User manual FRIGIDAIRE GLEH1642FS4 INSTALLATION

[. . . ] This symbol alerts you to hazards that can kill or hurt you or others. All safety messages will be preceded by the safety alert symbol and the word "DANGER" or "WARNING". DANGER You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. [. . . ] The maximum length of the exhaust system depends upon the type of duct used, number of elbows and type of exhaust hood. Do not exhaust dryer into a chimney, a wall, a ceiling, an attic, a crawl space or any concealed space of a building. If the dryer is not exhausted outdoors, some fine lint will be expelled into the laundry area. An accumulation of lint in any area of the home can create a health and fire hazard. Regularly inspect the outdoor exhaust opening and remove any accumulation of lint around the outdoor exhaust opening and in the surrounding area. The laundry center may be exhausted four (4) ways with rear flush installation: 1. 16 cm] rigid duct, 1 elbow down and 1 elbow right) Although vertical orientation of the exhaust system is acceptable, certain extenuating circumstances could affect the performance of the dryer: · Only the rigid metal duct work should be used. Venting vertical through a roof may expose the exhaust system to down drafts causing an increase in vent restriction. Running the exhaust system through an uninsulated area may cause condensation and faster accumulation of lint. 43 cm) away from the wall (flush to wall exhausting may be done by going below the dryer then sideways). An exhaust hood positioned to line up with the dryer exhaust can be installed directly through the outside wall. Installation MUST conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223. If codes allow, flexible metal tubing may be used to connect your dryer to the gas supply line. The dryer and its individual shutoff valve MUST be disconnected from the gas supply piping system during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3. The dryer MUST be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3. A laundry center installed in a bedroom, bathroom, recess or closet, MUST be exhausted outdoors. No other fuel burning appliance shall be installed in the same closet as the Gas laundry center. 2 square cm) of opening, equally divided at the top and bottom of the door, is required. Air openings are required to be unobstructed when a door is installed. The following illustrations show minimum clearance dimensions and air openings for proper operation in a recess or closet installation. Dryer MUST be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. If dryer is exhausted through the floor and area beneath the mobile home is enclosed, the exhaust system MUST terminate outside the enclosure with the termination securely fastened to the mobile home structure. [. . . ] Determine which water faucet is the HOT water faucet and carefully connect the bottom inlet hose to the HOT water faucet, tighten by hand, then tighten another 2/3 turn with pliers. Carefully connect the top inlet hose to the COLD water faucet, tighten by hand, then tighten another 2/3 turn with pliers. Semi-rigid or approved pipe from the gas supply line to the 3/8 inch (0. NOTE: Check to ensure the power is off at a circuit breaker fuse box before plugging the power cord into an outlet. [. . . ]