User manual FRIGIDAIRE GLVC25VBDB1

[. . . ] Operating the refrigerator with insufficient power can damage the compressor. ⷠDo not plug the unit into an outlet controlled by a wall switch or pull cord to prevent the refrigerator from being turned off accidently. The refrigerator should be located away from direct sunlight and heat sources such as registers, radiators or any cooking products. In accordance with ISO standards, your refrigerator is performance rated at Class N, 16°C to 32°C (61°F to 90°F), Class ST, 18°C to 38°C (65°F to 100°F), or at Class T, 18°C to 43°C (65°F to 110°F). [. . . ] When taking the refrigerator out of service for a period of time: · If equipped with an ice maker, raise the signal arm to its locked position (see Figure 1) and turn off the water supply at its valve. NOTE: When placing the refrigerator back into service, leave ice maker off until water supply is turned on. The refrigerator control should be set at midpoint of the dial for a period of 24 hours. The freezer control should be set at midpoint for a period of 24 hours. Turning the refrigerator control to "0" will shut down cooling in BOTH the refrigerator and the freezer compartments. ⷠWhen first setting the controls or when changing a setting, wait 24 hours for the temperature to stabilize before making more changes. If your refrigerator has an automatic ice maker, it will provide a continuous supply of ice. If not factory installed, the ice maker can be purchased as an accessory kit from your dealer. CAUTION: Ensure that the ice maker water supply tube is connected to a safe (potable) water pipe only. To stop ice maker, lift the wire signal arm until it clicks in and locks in the UP position. It is not necessary to stop the ice maker when the ice server is full. WARNING: Disconnect the service cord from wall before cleaning the refrigerator. Turning the refrigerator temperature control to "0" will not disconnect the power supply. cAUTION: · Do not use metallic scouring pads, brushes, abrasive cleaners, or alkaline solutions to clean the refrigerator. Wash the inside of the refrigerator and freezer with a mild household cleaner or a solution of 2 tablespoons of baking soda in 1 liter of warm water. Avoid getting water inside electrical parts such as the temperature controls or the light fixtures. Wash removable parts, storage bins and door gaskets in a mild household detergent and warm water. To prevent damage to your floor when moving the refrigerator, place a mat or rug under the front levelers or rollers. Since your refrigerator is equipped with a Never Clean condenser, there's no need to clean the condenser under normal operating conditions. If the refrigerator is operated under particularly dusty or greasy conditions, or if there is significant pet traffic in your home, it may be necessary to periodically clean the condenser for maximum efficiency. If cleaning of the condenser is necessary, remove the toe grille and use an extended vacuum attachment and condenser cleaning brush (available from your local dealer) to remove dust build-up from the condenser coils. If you are operating your refrigerator in a hot or humid climate it is important to follow these tips. [. . . ] Remove two outside screws on opposite side of refrigerator and install bottom hinge. Move hinge pin to other hole in hinge and tighten with adjustable wrench. Quite la bisagra superior con una llave inglesa o con un destornillador hexagonal de 3/8" y quite la puerta de la congeladora del pasador de bisagra central. Position refrigerator door onto lower hinge pin and screw center hinge pin through center hinge into top of door. [. . . ]