User manual FRIGIDAIRE RL1586H

[. . . ] Check and clean the outlet of melting water coming during defrosting regularly - a label inside the appliance warns you for this. If it is clogged the melting water gathered can cause earlier failure. For the safety of life and property keep the precautions of these user's instructions as the manufacturer is not responsible for damages caused by omission. Precautions for child safety Do not allow children to play with the packaging of the appliance. If you are discarding the appliance pull the plug out of the socket, cut the connection cable (as close to the appliance as you can) and remove the door to prevent playing children to suffer electric shock or to close themselves into it. Safety precautions for installation Put the appliance to the wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn. [. . . ] Turning the control button towards the bigger numbers cooling becomes more and more intensive. Setting the knob of the thermostatic control to 3 the temperature starting automatically in the fresh food compartment is about +5 °C or below. The temperature coming about in the refrigerator is effected by not only the position of the thermostatic control but the ambient temperature, frequency of door openings and the quantity of food put into it newly, etc. This does not cause damages to the appliance. Hints for storage 1. When placing the different kinds of food take into consideration the sketch below in figure: Confectionery, ready-cooked foods, foods in dishes, fresh meat, cold cuts, drinks 2. Big bottles, drinks 6 Storage time and temperature of foods The storage time can not be determined exactly in advance, as it depends on the freshness and handling of the cooled food. If you do not want to use up deep-frozen foods bought immediately they can be stored for about 1 day (until dissolving) in this type of refrigerator. If the deepfrozen food has already dissolved, refreezing is not recommended, it has to be used up as soon as possible. Do not leave the door open longer than necessary and avoid unnecessary openings. Put warm foods into the appliance only when they are at room temperature. Keep the condenser clean at the back of the appliance. The appliance and environment This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Wash the inside of the appliance using lukewarm water and mild detergent. After cleaning wipe out the inside of the appliance. 9 Placement The ambient temperature has an effect on the energy consumption and proper operation of the appliance. When placing, take into consideration that it is practical to operate the appliance between ambient temperature limits according to the climate class that is given in the chart below and can be found in the data label. + 38 °C If the ambient temperature goes below the lower data the temperature of the cooling compartment can go beyond the prescribed temperature. If the ambient temperature goes beyond the upper data this means longer operating time of the compressor, breakdown in the automatic defrosting increasing temperature in the cooling compartment or increasing energy consumption. This can be achieved by two adjustable feet (1) at the bottom in front. 1-1 piece of distance washer (2) are accessories of the adjustable feet. Do not stand the appliance on a sunny place or close to a radiator or cooker. If it is unavoidable because of furnishing and the appliance has to be stood near a cooker take these minimum distances into consideration: In case of gas or electric cooker 3 cm must be left, when it is less put a 0, 5 - 1 cm non-flam insulation between the two appliances. In case of oil or coal-fired stove the distance must be 30 cms since they give off more heat. The refrigerator is designed to operate when it is totally pushed to the wall. [. . . ] After unscrewing turn over the pin in the door holder plate in the direction of the arrow. Fit and fix the door holder plate on the other side without displacing the door. Put the appliance to its place, set it level and plug it into the mains socket. In case you do not want to perform the procedures above, call the nearest brand-mark service. [. . . ]