User manual FRIGIDAIRE TD920

[. . . ] Push metal cabinet side inward to release plastic tabs on each side of Front Panel (see Fig. When pulling out, front panel will also pull free from vent control lever. Remove shipping screws from top of unit and also on both sides by the base if installed. With the aid of an assistant, hold the cabinet while pulling on the base pan handle (see FIG. [. . . ] Add two foam inserts to holes in top of cabinet where shipping screws were removed from. Except 22, 000BTU model, other heavy duty models (24, 000~28, 500BTU) come with internal shipping packaging. THIS PACKAGING AND PLASTIC TIES MUST BE REMOVED PRIOR TO INSTALLING THE AIR CONDITIONER BACK INTO THE CABINET. FIG. 7 FIG. 5 shipping Shipping Packaging screws FIG. 6 Plastic tie 2 Install Top Angle Rail and Side Retainers 1. From inside of cabinet insert 3 screws to attach each side retainer as shown in Fig. Attach side retainers with flat side against cabinet and angled edge toward rear of cabinet. 3 Assemble Window Filler Panels 1. Slide "I" section at end of window filler panel into side retainer on each side of the cabinet (see FIG. On each side of cabinet, insert top and bottom legs of window filler panel frame into channel in the top and bottom angle rails. Insert a 7/16" locking screw and flat washer into hole on top leg of each window filler panel (see section 6). Fill in the space from the opending to the studs with wood spacers, as shown. Nail frame to spacers to spacers with front flush with dry wall. NOTE: If wall thickness is 8-1/2" or more, add alumimum flashing over bottom of frame opening to assure no water can enter area between inner and outer wall. NAIL SPACERS TO STUDS FIG. 3 FIG. 4 CAULK AS REQUIRED LEVEL ALUMINUM FLASHING OVER BOTTOM OF FRAME 3 Prepare and Install Cabinet 1. Slide air conditioner from cabinet; refer back to Step 1 of Window Mounting. Place cabinet into opening with bottom rail resting firmly on bottom board of wooden frame. Unit must tilt back 5/16" to 3/8" for proper water drainage. (See FIG. 6 following) FIG. 5 FIG. 6 WOOD SCREW Side Louvers Refer to Step 5 of Window Mounting for assembly of support brackets. Nail a wooden strip to the outside wall for the angle sill bracket to rest upon. Screw or nail cabinet to wooden frame using shims as needed to eliminate cabinet distortion. Remember to maintain proper tilt as described in Step 3. 7 Installation Instructions FIG. 7 FIG. 8 Support bracket Sill angle bracket Wooden strip 6. [. . . ] Screw or nail cabinet to wooden frame using shims as needed to eliminate cabinet distortion. Remember to maintain proper tilt as described in Step 3. 7 Installation Instructions FIG. 7 FIG. 8 Support bracket Sill angle bracket Wooden strip 6. Install air conditioner into cabinet by following all steps in Step 9 of Window Mounting. OPTIONAL: Caulking and installation of trim on interior wall may be done. [. . . ]