User manual FUTUBA R603FS

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual FUTUBA R603FS. We hope that this FUTUBA R603FS user guide will be useful to you.


FUTUBA R603FS : Download the complete user guide (1071 Ko)

Manual abstract: user guide FUTUBA R603FS

Detailed instructions for use are in the User's Guide.

[. . . ] For cars only 1M23N17303 Before using your new 2. 4GHz system, please read this manual thoroughly and use the system properly and safely. After reading this manual, store it in a safe place. 2. 4GHz System PK-FSM2. 4G Module and R603FS Receiver Thank you for purchasing a PK-FSM2. 4G module and an R603FS receiver. [. . . ] Otherwise, the operating may become shorter. WARNING 78 PK-FSM2. 4G Module Module Cover T3PK Transmitter 456 23 Installing the PK-FSM2. 4G/R603FS Antenna PK-FSM2. 4G Module (Antenna Moving Range) Antenna 901 23 Receiver installation How to turn on the power Antenna tube 1 Install the R603FS receiver on the car as follow; Note: The operating range may become shorter, although depending on where the receiver and the antenna are mounted. A certain ID number is given to the receiver automatically. Identifying this ID number, the system will minimize the interference from other transmitters. Antenna antenna Install thethe figure. in the higher place as shown in Do not cut the antenna. the from the Keep and antenna awaysources asmotor, ESC other noise possible as you can. WARNING 1 2 Bring the transmitter and the receiver close to each other within one meter. Turn on the transmitter. Coaxial cable Note: Check the LED on the module. Parameter check for 0. 5 seconds after power-on Transmitting signals F/S is activated by the tactile switch of the module. (PPM mode) Unrecoverable failure (EEPROM, etc. ) PCM is improperly selected. Red: On Green: On Green: Blink Red and Green turn on alternatively. Red: Blink Put theit. antenna in the antenna tube to protect R603FS Do not bend the coaxial cable. If there issomething of getting wet, foamthe receivavoid a chance put er in a waterproof bag or balloon to avoid water. 3 4 Turn on the receiver. Push the tactile switch of the receiver. Always use R603FS under the following conditions; Powersupply;6VNicdbattery(PPM/HRSmode) Servo;6VtypeFutabaDigitalServo(HRSmode) CAUTION Note: Check the LED of the receiver. No signal reception Receiving signals Receiving signals, but ID is unmatched. Unrecoverable failure (EEPROM, etc. ) Red : On Green: On Green: Blink Red and Green turn on alternatively. *Iftheconditionsaredifferent, controlisimpossibleortheservomaybedamaged. Frequency Range Setting The frequency range of 2. 4GHz system differs according to regulations of the country that it is used in. How to Set the F/S Position PPM mode only: 1 Use the rotar y switches of the module to select the frequency range mode. 901 1 *HRS mode: Set the F/S function by the transmitter. Move and hold the throttle trigger (stick) to the F/S servo position where you want to set (slow side) then push the tactile switch on the module. The LED blinks green. Note: Always set again when turning on the power. 0: GENERAL (2405. 376MHz - 2477. 056MHz) 8: FRANCE (2407. 424MHz - 2450. 432MHz) 78 If usingtothis system in France, always use it to set the rotary switch "8". *Inothercountries, both"0:GENERAL"and"8:FRANCE"areavailable. WARNING Usage Precaution should be before turning Special attention are runningpaid other airplanes on the system while other cars or are flying because the 2. 4GHz RC system could potentially affect them. WARNING Be sure to set the Fail Safe function. Special Markings; Pay special attention to the safety at the parts of this manual that are indicated by the following marks. [Symbol] ; Prohibited ; Mandatory WARNING 23 456 Battery F/S function The Battery F/S function becomes active when the voltage of the receiver becomes 4. 75V or less. [. . . ] Procedures which may lead to a dangerous condition or cause death or serious injury to the user if not carried out properly, or procedures where the probability of superficial injury or physical damage is high. Procedures where the possibility of serious injury to the user is small, but there is a danger of injury, or physical damage, if not carried out properly. Mark FUTABA CORPORATION Phone: (043) 296-5118 Facsimile: (043) 296-5124 Makuhari Techno Garden Bldg. , B6F 1-3 Nakase, Mihama-ku, Chiba 261-8555, Japan ©FUTABACORPORATION2006, 09(1) [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE FUTUBA R603FS




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual FUTUBA R603FS will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.