User manual GRACO JUNIOR MINI

[. . . ] DO NOT use this car seat along with component parts of other manufacturers. € • • • • DO NOT use this car seat if it has damaged or missing parts. € DO NOT have your child in unfitted clothes because this may prevent your child from being properly and securely fastened by the shoulder harnesses and the harnesses between thighs. DO NOT leave this car seat unbelted or unsecured in your vehicle because unsecured car seat can be thrown around and may injure occupants in a sharp turn, sudden stop, or collision. [. . . ] Product Details Product Description: Graco Gr 0+/1 Model Number: 8H98 Suitable for: child weighing below 18kg (or under 4 years old) Gr. 8 5-point safety buckle Harness adjuster Angle adjustment button Secondary latch Top bar juncture Rear facing seat belt hook Body Protective shoulder straps Fig. 3 Anti-slippery pad Reclining Adjustment After adjustment, please move the car seat back and forth to make sure if the car seat is securely fastened to the vehicle seat. Forward Facing Mode (for child between 9~18kg) There are four reclining angles 1~ 4 (Fig. Simply press the angle adjustment button to adjust the car seat angles (Fig. Rear Facing Mode (for child under 13kg) Press the secondary latch first and then the reclining adjustment button (Fig. Shoulder harnesses Height Adjustment Improper adjustment of shoulder height may throw your child off the car seat when accident occurs. Make sure the shoulder height is not too high or too low before installing this car seat. 7) 2 Move the slide lever up or down by pressing the harness height adjuster button (Fig. 3 Adjust the shoulder harness to appropriate height of insertion outlet cover after the height adjustment (Fig. 16 4 The shoulder harness MUST lay across child’s shoulders according to height (Fig. 3 Attach both shoulder straps together then insert it into the harness buckle (Fig. 4 Pull the harness adjuster webbing to adjust the shoulder strips to suitable length that allow your child tightly secured at the car seat (Fig. Use cold water for hand washing and refer to the washing label attached on the car seat for correct method. The seat cover should not be replaced with any other than the one recommended by the manufacturer because the cover constitutes an integral part of the restraint performance. 19 4 To remove the seat pad, release the attaching pads on both side of the seat pad.  Pull the harnesses and straps out through the designated opening on the seat pad.  Stuff the edge of the seat pad into the back plastic cover of the seat, and attach the attaching pads to secure the seat pad (Fig. Insert the protective shoulder strap from one side to the other, so that the webbing in between passes through the seat back (Fig. Additional Information 1 Make sure that your car seat is securely fastened in the vehicle when not in use in case it throws around and injures occupants in a sharp turn, sudden stop or collision. 2 DO NOT make any modification to the structure or safety belt system of the car seat. For your child’s safety, DO check or immediately replace your car seat after an accident of any kind. [. . . ] Om någon del av stolen eller bältet fastnar i dörren eller hamnar under sätet kan stolen utgöra en fara för övriga passagerare eller förhindra att dörren stängs ordentligt. 1 Fäst innerkuddarna på stolen (inbegripet huvuddyna, sittdyna och grenband) • • • Innerkudden är avsedd för att ge ett barn upp till 6 månader extra skydd och komfort. Sørg for, at skulderstropperne er indstillet korrekt (hverken for højt eller for lavt) inden montering af autostolen.  Stop siderne på sædepuden ind i rygbeklædningen på stolen, og fastgør puderne for at sikre sædepuden (Fig. [. . . ]