User manual GUITAR MAN GM11

[. . . ] 13) Learn to get to know the parts which make up your dishwasher, you will use it better for it. This is where you will find the description of the controls and the internal parts. 14) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 15) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. [. . . ] If you have changed your mind and wish to start the wash cycle immediately, press button "P" until the countdown is fully reset. Indicator light "H" will turn off and the cycle will start at the sound of a beep. The delayed start is also reset automatically should you fail to select the wash cycle within 15 seconds. ARISTON DISHWASHER - Instructions for installation and use 15 D ISHWASHER The detergent Loading the detergent To open lid A, press button B. The detergent should be poured into the two containers C and D up to the rim. If you prefer to use the detergent in tablet form, then place one inside the container “D” and close the lid. B C Detergent and rinse aid D Useful tips • Use the right amount of detergent: if you use too much, you will not get cleaner dishes, but just more environmental pollution. Check whether there is any detergent residue on the edges of the dispenser. • Keep your dishwasher detergent and rinse aid in a cool, dry place and away from children. The rinse aid container is situated on the inside of the door: It should be filled up when the low rinse aid indicator light "F" flashes. You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. 18 ARISTON DISHWASHER - Instructions for installation and use After having bought or moved your dishwasher to another home, a correct installation ensures that your dishwasher will operate smoothly and efficiently. Your dishwasher, you can even Your dishwasher can be supplied place it so that its sides or back with hot water from the mains panel are side by side with furniture supply (if you have a central heating or up against the wall. The system with radiators) at a tempedishwasher is provided with water rature of no more than 60°C. Supply and drain hoses, which can In this case, the wash cycle time be directed towards the left or right will be about 15 minutes shorter to facilitate appropriate and the wash will be slightly less installation. Hot water supply following the Once the appliance is positioned, same procedures as those indicated adjust the feet by screwing them in for the cold water connection. Or out depending on how high you want it and to level it so that it is Anti-flooding protection horizontal. Make sure that it is not Your dishwasher is provided with a inclined more than 2 degrees. If the special system which blocks the appliance is level, it will help ensure water supply in the event of leaks its correct operation. Insert the appliance into the cutout an inner red hose, which can both First of all, check that the mains and then adjust the height using the withstand extremely high pres- voltage and frequency values screws located on the front bottom sures. Should the inner hose break, correspond to those stated on the part of the machine. Use a the outer hose will consequently rating plate located on the stainless screwdriver to turn the screws in turn red. [. . . ] The food particles are removed from the wash water, allowing it to be recirculated during the cycle, filtered perfectly. For this reason, it is a good idea to remove the larger food particles trapped inside the cup “C” and the semi-circular filter A after each wash; pull the cup handle upwards to remove them. The entire filter assembly should be cleaned thoroughly once a month: cup C + semi-circular filter A + cylindrical filter B. Reassemble the filter parts (as shown in the figure) and reinsert the whole assembly into the dishwasher. [. . . ]