User manual HAIER HWF06 XC3

[. . . ] HWF06XC3 0010547047 11-13 14-15 2-way airflow easy access filters control panel 2. [. . . ] The wood strip should be thick enough to raise the height of the window sill so that the unit can be installed without interference by the storm window frame (STORM WINDOW FRAME) or wood strip (OUTDOORS) to help condensation to drain properly to the outside. Install a second wood strip (approximately 6 long by 3/2 wide and same thickness as first strip) in the center of the outer sill flush against the back off the inner sill. If the distance between STORM WINDOW FRAME and WOOD STRIP MOUNTED ON TOP OF INNER SILL is more than 1 , two of wood strip are not necessary. I N D O O R S INNER SILL O U T D O O OUTER R SILL S 1 MAX. WOOD STRIP MOUNTED ON TOP OF INNER SILL 3/4 CLEARANCE STORM WINDOW FRAME WOOD STRIP I FOR BASEPAN N ANGLE D O O R S O U T D O O R S INNER SILL OUTER SILL LOCATING UNIT IN WINDOW Open the window and mark center line on the center of the inner sill. ATTACH BASEPAN ANGLE Install the basepan angle behind the inner window sill, with the short side of basepan angle as shown. INNER SILL SHORT SCREW13/32" CENTER LINE INSIDE 8 INNER SILL CENTER LINE OUTER SILL INDOOR SIDE SHORT SIDE OUTSIDE 8 BASEPAN ANGLE 12 INSTALL THE AIR CONDITIONER IN THE WINDOW Carefully lift the air conditioner and slide it into the open window. Make sure the bottom guide of the air conditioner drops into the notches of the basepan angle. While steadying the air conditioner , carefully bring the window sash down behind the upper guide of the air conditioner. WINDOW FRAME UPPER GUIDE ABOUT 1/4 BOTTOM GUIDE BASEPAN ANGLE INSTALL THE SEAL GASKET AND SASH LOCK Extend the side curtains to fill the window opening using 4 wood screws 31/32" to secure them. Stuff the sash seal between the glass and the window to prevent air and insects from getting into the room. [. . . ] To clean the front panels or the cabinet DO NOT use harsh chemicals, abrasives, ammonia, chlorine, bleach, concentrated detergents, solvents or metal scouring pads. Always use a soft cloth dampened with water or mild soap and water solution to wipe the front if the cabinet. 14 15 (see page 7) (see page 13) 16 17 [. . . ]