User manual HP LASERJET P3005DN

[. . . ] HP LaserJet P3005 Series printers User Guide HP LaserJet P3005 Series printers User Guide Copyright and License © 2006 Copyright Hewlett-Packard Development Company, L. P. Reproduction, adaptation, or translation without prior written permission is prohibited, except as allowed under the copyright laws. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. [. . . ] In the Cover Page Type pop-up menu, select the message that you want to print on the cover page. NOTE To print a blank cover page, select Standard as the Cover Page Type. 78 Chapter 5 Print ENWW Print multiple pages on one sheet of paper You can print more than one page on a single sheet of paper. This feature provides a cost-effective way to print draft pages. 1. Next to Pages per Sheet, select the number of pages that you want to print on each sheet (1, 2, 4, 6, 9, or 16). Next to Layout Direction, select the order and placement of the pages on the sheet. Next to Borders, select the type of border to print around each page on the sheet. Print on both sides of the paper When duplex printing is available, you can automatically print on both sides of a page. Otherwise, you can manually print on both sides of a page by feeding the paper through the device a second time. CAUTION To avoid jams, do not load paper that is heavier than 105 g/m2 (28-lb bond). Use automatic duplex printing 1. Insert enough paper into one of the trays to accommodate the print job. If you are loading special paper such as letterhead, load it in one of the following ways: 2. For tray 1, load the letterhead paper face-up with the bottom edge feeding into the printer first. For all other trays, load the letterhead paper face-down with the top edge at the back of the tray. Open the printer driver (see Open the printer drivers). Next to Two Sided Printing, select either Long-Edge Binding or Short-Edge Binding. Click Print. ENWW Use features in the Macintosh device driver 79 Print on both sides manually 1. Insert enough paper into one of the trays to accommodate the print job. If you are loading special paper such as letterhead, load it in one of the following ways: For tray 1, load the letterhead paper face-up with the bottom edge feeding into the printer first. For all other trays, load the letterhead paper face-down with the top edge at the back of the tray. CAUTION To avoid jams, do not load paper that is heavier than 105 g/m2 (28-lb bond). NOTE If the Manual Duplex option is not enabled, select Manually Print on 2nd Side. Follow the instructions in the pop-up window that appears on the computer screen before replacing the output stack in tray 1 for printing the second half. Insert the printed stack face-up with the bottom edge feeding into the printer first in tray 1. If prompted, press the appropriate control-panel button to continue. 80 Chapter 5 Print ENWW Cancel a print job You can stop a print request by using the device control panel or using your software program. [. . . ] Also called "two-sided printing. " EIO Abbreviation for "enhanced input/output. " A hardware interface that is used to add a print server, network adaptor, hard disk, or other plug-in item for HP devices. Emulated PostScript Software that emulates Adobe PostScript, a programming language that describes the appearance of the printed page. firmware Programming instructions that are stored in a read-only memory unit inside the device. fuser The assembly that uses heat to fuse the toner onto the print media. [. . . ]