User manual HP OFFICEJET PRO L7590

[. . . ] HP Officejet Pro L7300/L7500/L7600/L7700 User Guide HP Officejet Pro L7300/L7500/ L7600/L7700 All-in-One series User Guide Copyright information © 2007 Copyright Hewlett-Packard Development Company, L. P. Edition 1, 10/2006 Reproduction, adaptation or translation without prior written permission is prohibited, except as allowed under the copyright laws. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. [. . . ] Using the phone cord supplied in the box with the device, connect one end to your telephone wall jack, then connect the other end to the port labeled 1-LINE on the back of the device. NOTE: If you do not use the supplied cord to connect from the telephone wall jack to the device, you might not be able to fax successfully. This special phone cord is different from the phone cords you might already have in your home or office. If your modem software is set to receive faxes to your computer automatically, turn off that setting. NOTE: If you do not turn off the automatic fax reception setting in your modem software, the device will not be able to receive faxes. (Optional) Change the Rings to Answer setting to the lowest setting (two rings). When the phone rings, the device automatically answers after the number of rings you set in the Rings to Answer setting. The device begins emitting fax reception tones to the sending fax machine and receives the fax. Set up the device with a computer DSL/ADSL modem If you have a DSL line and use that phone line to send faxes, follow these instructions to set up your fax. 112 Configure and manage 1 2 3 Telephone wall jack Parallel splitter DSL/ADSL splitter Connect one end of the phone jack that was supplied with the device to connect to the 1-LINE port on the back of the device. Connect the other end of the cord to the DSL/ADSL filter. 4 5 Computer Computer DSL/ADSL modem NOTE: You will need to purchase a parallel splitter (also called a coupler). A parallel splitter has one RJ-11 port on the front and two RJ-11 ports on the back. Do not use a 2­line phone splitter, a serial splitter, or a parallel splitter which has two RJ-11 ports on the front and a plug on the back. To set up the device with a computer DSL/ADSL modem 1. Using the phone cord provided in the box with the device, connect one end to the DSL filter, and then connect the other end to the port labeled 1-LINE on the back of the device. NOTE: If you do not use the supplied cord to connect from the DSL filter to the back of the device, you might not be able to fax successfully. This special phone cord is different from the phone cords you might already have in your home or office. Run a fax test. When the phone rings, the device automatically answers after the number of rings you set in the Rings to Answer setting. The device begins emitting fax reception tones to the sending fax machine and receives the fax. Case H: Shared voice/fax line with computer modem If you receive both voice calls and fax calls at the same phone number, and you also have a computer modem connected on this phone line, set up the device as described in this section. Set up faxing for the device (some models only) 113 Chapter 9 NOTE: Since your computer modem shares the phone line with the device, you cannot use both your modem and the device simultaneously. For example, you cannot use the device for faxing while you are using your computer modem to send an e-mail or access the Internet. · · Shared voice/fax with computer dial-up modem Shared voice/fax with computer DSL/ADSL modem Shared voice/fax with computer dial-up modem If you use your phone line for both fax and telephone calls, use these instructions to set up your fax. There are two different ways to set up the device with your computer based on the number of phone ports on your computer. Before you begin, check your computer to see if it has one or two phone ports. [. . . ] For further information, contact: Manager of Corporate Product Regulations Hewlett-Packard Company 3000 Hanover Street Palo Alto, CA 94304 (650) 857-1501 214 Regulatory information Exposure to radio frequency radiation (wireless products only) FCC statement 215 Appendix D Notice to users of the U. S. telephone network 216 Regulatory information Notice to users of the Canadian telephone network Notice to users of the Canadian telephone network 217 Appendix D Notice to users in the European Economic Area Other regulatory information · · · · · EMI statement (Korea) VCCI statement (Japan) Regulatory model number Power cord statement LED classification EMI statement (Korea) 218 Regulatory information VCCI statement (Japan) Regulatory model number For regulatory identification purposes, your product is assigned a Regulatory Model Number. The Regulatory Model Number for your product is SNPRC-0602­01 or SNPRC-0602­02. This regulatory number should not be confused with the marketing name (HP Officejet Pro L7300/ L7500/L7600/L7700) or product number (CB778A, C8157A, C8158A, C8159A). Power cord statement The power cord cannot be repaired. [. . . ]