User manual HP PHOTOSMART C3180 Basics Guide

[. . . ] HP Photosmart C3100 All-in-One series Basics Guide HP Photosmart C3100 All-in-One series Basics Guide 2006 Hewlett-Packard Development Company, L. P. Adobe and the Acrobat logo are trademarks of Adobe Systems Incorporated. Windows, Windows NT, Windows ME, Windows XP, and Windows 2000 are U. S. Intel and Pentium are trademarks or registered trademarks of Intel Corporation or its subsidiaries in the United States and other countries. Energy Star and Energy Star logo are US registered marks of the United States Environmental Protection Agency. [. . . ] For more information, go to the following website: www. hp. com/hpinfo/globalcitizenship/environment/recycle/inkjet. html Remove the new print cartridge from its packaging and, being careful to touch only the black plastic, gently remove the plastic tape by using the pink pull tab. 1 2 3 Copper-colored contacts Plastic tape with pink pull tab (must be removed before installing) Ink nozzles under tape Caution Do not touch the copper-colored contacts or ink nozzles. Touching these parts can result in clogs, ink failure, and bad electrical connections. Basics Guide 15 Chapter 1 HP All-in-One overview 8. Slide the new print cartridge forward into the empty slot. Then gently push on the upper part of the print cartridge forward until it clicks into the socket. If you are installing the tri-color print cartridge, slide it into the left slot. If you are installing a black or photo print cartridge, slide it into the right slot. 9. Close the print cartridge door. If you installed a new print cartridge, the HP All-in-One prints a print cartridge alignment sheet. Note If you have colored paper loaded in the input tray when you align the print cartridges, the alignment will fail. Load unused plain white paper into the input tray, and then try the alignment again. If the alignment fails again, you might have a defective sensor or print cartridge. If prompted, choose your country/region, and then click Contact HP for information on calling for technical support. Clean the HP All-in-One To ensure that your copies and scans remain clear, you might need to clean the glass and lid backing. Clean the glass Clean the lid backing 16 HP Photosmart C3100 All-in-One series Clean the glass Glass that is dirty from fingerprints, smudges, hair, and dust on the main glass surface slows down performance and affects the accuracy of some features. Clean the glass with a soft cloth or sponge slightly moistened with a nonabrasive glass cleaner. Caution Do not use abrasives, acetone, benzene, or carbon tetrachloride on the glass, since they can damage it. Plug in the power cord, and then turn on the HP All-in-One. HP All-in-One overview Clean the lid backing Minor debris can accumulate on the white document backing located underneath the lid of the HP All-in-One. Clean the white document backing with a soft cloth or sponge slightly moistened with a mild soap and warm water. Caution Do not use paper-based wipes, as these might scratch the backing. If further cleaning is needed, repeat the previous steps using isopropyl (rubbing) alcohol, and wipe the backing thoroughly with a damp cloth to remove any residual alcohol. Caution Be careful not to spill alcohol on the glass or exterior of the HP All-in-One, as this might damage the device. Plug in the power cord, and then turn on the HP All-in-One. Basics Guide 17 2 Troubleshooting and support This chapter contains troubleshooting information for the HP All-in-One. Specific information is provided for installation and configuration issues, and some operational topics. For more troubleshooting information, see the onscreen Help that came with your software. Many issues are caused when the HP All-in-One is connected to the computer using a USB cable before the HP All-in-One software is installed on the computer. If you connected the HP Allin-One to your computer before the software installation screen prompts you to do so, you must follow these steps: Troubleshooting common setup issues Troubleshooting and support 1. [. . . ] However, if printer failure or damage is attributable to the use of a non-HP or refilled ink cartridge, HP will charge its standard time and materials charges to service the printer for the particular failure or damage. If HP receives, during the applicable warranty period, notice of a defect in any product which is covered by HP's warranty, HP shall either repair or replace the product, at HP's option. If HP is unable to repair or replace, as applicable, a defective product which is covered by HP's warranty, HP shall, within a reasonable time after being notified of the defect, refund the purchase price for the product. HP shall have no obligation to repair, replace, or refund until the customer returns the defective product to HP. [. . . ]