User manual HYOSUNG GT250 R FI

[. . . ] WARNING This owner's manual contains important safety information. Please read it carefully. This manual should be considered a permanent part of the motorcycle and should remain with the motorcycle when resold or otherwise transferred to a new owner or operator. The manual contains important safety information and instructions which should be read carefully before operating the motorcycle. 1 2 FOREWORD THANK YOU for choosing Hyosung motorcycle. We at Hyosung have designed, tested and produced this motorcycle using the most modern technology available to provide you with much happy, enjoyable, safe riding. [. . . ] If the transmission is not in neutral, you can only start the engine with pulling in clutch lever and side stand up. Make sure that the side stand igintion interlock system is working properly before riding. CAUTION always come on the position lamp, meter lamp, tail lamp and license plate lamp when starting the engine. 39 WARNING Running the engine indoors or in a garage can be hazardous. Exhaust gas contains carbon monoxide, a gas that is colorless and odorless and can cause death or severe injury. Only run the engine outdoors where there is a fresh air. CAUTION Running the engine too long without riding may cause the engine to overheat. Overheating can result in damage to internal engine components and discoloration of exhaust pipes. Shut the engine off if you cannot begin your ride promptly. CAUTION The following happens : " on the the "FI" check lamp " instrument panel should comes on. This lamp should go out after three seconds whenever the ignition switch is set to "ON" position. If this lamp does not come on when the ignition switch is set to "ON" position or fails to go out after three seconds whenever the ignition switch is set to "ON" position, contact an authorized Hyosung dealer. CAUTION Take off the starter switch right after started. Do not engage the starting motor for more than five seconds at a time as it may overheat the wiring harness and starting motor. If the engine does not start after several attempts, check the fuel supply and igintion system. (Refer for Page 68) 40 STARTING OFF WARNING Riding these motorcycles at excessive speed increases your chances of losing control of the motorcycle. Always ride within the limits of your skills, your motorcycle, and the riding conditions. CAUTION After three seconds whenever the ignition switch is set to "ON" position, "FI" check lamp " " must goes out. If this lamp stays on or comes on during normal operation, it means that the fuel injection system is not operating correctly. Do not use the motorcycle with disabled fuel injection system, in order to avoid damaging the engine components. WARNING Removing your hands from the handlebars or feet from the footrests during operation can be hazardous. If you remove even one hand or foot from the motorcycle, you can reduce your ability to control the motorcycle. Always keep both hands on the handlebars and both feet on the footrests of your motorcycle during operation. CAUTION Avoid pressing the starter switch when the engine is running, or starting motor damage. WARNING Sudden side winds, which can occur when being passed by large vehicles, at tunnel exits or in hilly areas, can upset your control. Reduce your speed and be alert to side winds. 41 Pull the clutch lever in and pause momentarily. Turn the throttle grip toward you and at the same time release the clutch lever gently and smoothly. To shift to the next higher gear, accelerate gently, then close the throttle and pull the clutch lever in simultaneously. Lift the gearshift lever upward to select the next gear and release the clutch lever and open the throttle again. Select the gears in this manner until fifth gear is reached. USING THE TRANSMISSION The transmission is provided to keep the engine operating smoothly in its normal operating speed range. The gear ratios have been carefully chosen to meet the characteristics of the engine. [. . . ] While holding the spark plug firmly against the crankcase of the engine, push the starter switch with the ignition switch in the "ON" position, the engine " position, the stop switch in the " transmission in neutral, the side stand up and the clutch disengaged. If the ignition system is operating properly, a blue spark should jump a cross the spark plug gap. If there is still no spark, consult your Hyosung dealer for repairs. The fuse box is located behind the rear seat. If the engine suddenly stops while running or any electrical system fails to operate then the fuse must be checked. [. . . ]