User manual HYOSUNG GT650S

[. . . ] This manual should be considered a permanent part of the motorcycle and should remain with the motorcycle when resold or otherwise transferred to a new owner or operator. The manual contains important safety information and instructions which should be read carefully before operating the motorcycle. 1 (Standard type) 2 (Sports type) 3 FOREWORD THANK YOU for choosing Hyosung motorcycle. We at Hyosung have designed, tested and produced these motorcycles using the most modern technology available to provide you with much happy, enjoyable, safe riding. Motorcycling is one of the most exhilarating sports and insure you to enjoy riding and you should become thoroughly familiar with the information presented in this Owner's Manual before riding the motorcycle. [. . . ] Before replacing the engine oil filter cap , be sure to check that the engine oil filter spring and the" O" are installed ring correctly. Use new" O" each time the ring engine oil filter element is replaced. Replace the oil filter cap and tighten the nuts securely but do not over tighten them. OIL FILTER INSTALLATION INSERTION DIRECTION LUSTER MATERIAL HYOSUNG 16510HN910 OUTSIDE CAUTION When install the oil filter, necessarily, " HYOSUNG" " character and " 16510HN910" ' NO. install toward part' s the outside, otherwise can damage the engine. 47 9. Approximately 3, 200 of oil will be required. COOLANT COOLANT LEVEL CAUTION Approximately 3, 000 of oil must be required when changing oil only without replacing the oil filter. CAUTION In case of the engine oil pouring excessively, the engine output being made insufficient. Confirm the oil level with the oil level lens after waiting about a minute next to stopping the engine. The oil level is located between the "Lower line(L)" the and "Upper line(F)" . When below the"Lower line(L)" refill the , oil between the"Lower line(L)"and the "Upper line(F)" . The coolant should be kept between the "F" "L" (FULL) and (LOW) level lines in the reservoir tank at all times. Inspect the level every time before riding while the motorcycle vertically. If the coolant is found lower "L"level line, add properly mixed than the coolant in the following way : If the reservoir tank is emptied, pour the engine coolant to the reservoir tank and radiator. Remove the filler cap and add properly mixed coolant through the filler hole "F" line. until it reaches the Refer to the FUEL, ENGINE OIL AND COOLANT RECOMMENDATION section (14 page). 48 WARNING Engine coolant is harmful or fatal if swallowed or inhaled. If coolant gets in eyes, flush eyes with water and seek medical attention. Keep out of the reach of children and aminals. SIDE COWLING INNER (FOR & ) & have the "side cowling inner " at the rightside. To disassemble the "side cowling inner", remove the two bolts . WARNING Do not open the radiator cap when the engine is hot, as you may be injured by escaping hot liquid or vapor. NOTE Adding only water will dilute the engine coolant and reduce its effectiveness. Add 50:50 mixture of engine coolant and water. CHANGING THE COOLANT Change the coolant every two years. NOTE About 1. 6 of coolant will required when filling the radiator and reservoir tank. 49 RIDING TIPS STARTING THE ENGINE Before attempting to start the engine make sure: 1. Inspect every day once before riding the motorcycle. When the engine is cold : 1. Immediately after the engine starts, return the choke lever halfway and warm up the engine. Return the choke lever all the way back to its disengaged position. When the engine is warm : 1. Push the starter switch. CAUTION Operation of the carburetor choke system is not necessary when the engine is warm. WARNING The is equipped with the side stand ignition interlock system. If the transmission is in neutral or side stand up, you can only start the engine with pulling in the clutch lever. [. . . ] If there is still no spark, consult your Hyosung dealer for repairs. The fuse box is located behind the rear seat. If the engine suddenly stops while running or any electrical system fails to operate then the fuse must be checked. In case a fuse blows there is a 30A for main and 15A for head lamp spare fuse. 15A head lamp fuse protects the head lamp and high beam indicator lamp. WARNING Performing the spark test improperly can cause a high voltage electrical shock or an explosion. [. . . ]