User manual HYOSUNG GV 650 EFI

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual HYOSUNG GV 650 EFI. We hope that this HYOSUNG GV 650 EFI user guide will be useful to you.


HYOSUNG GV 650 EFI : Download the complete user guide (2516 Ko)

Manual abstract: user guide HYOSUNG GV 650 EFI

Detailed instructions for use are in the User's Guide.

[. . . ] WARNING This owner's manual contains important safety information. Please read it carefully. This manual should be considered a permanent part of the motorcycle and should remain with the motorcycle when resold or otherwise transferred to a new owner or operator. The manual contains important safety information and instructions which should be read carefully before operating the motorcycle. 1 FOREWORD THANK YOU for choosing Hyosung motorcycle. We at Hyosung have designed, tested and produced this motorcycle using the most modern technology available to provide you with much happy, enjoyable, safe riding. [. . . ] holding the filter 36 WARNING Engine oil and exhaust pipes can be hot enough to burn you. Wait until the oil drain plug and exhaust pipes are cool enough to touch with bare hands before draining oil. WARNING CAUTION Insert the filter so that surface of the filter hole turn toward the engine. Children and pets may be harmed by swallowing new or used engine oil or solvent. Continuous contact with used engine oil has been found to cause skin cancer in laboratory animals. Wash with soap if oil or solvent contact your skin. OIL FILTER INSTALLATION INSERTION DIRECTION LUSTER MATERIAL HYOSUNG 16510HN910 OUTSIDE 6. Replace the engine oil filter one. with a new CAUTION When install the oil filter, necessarily, "HYOSUNG" character and "16510HN910" part's NO. Before replacing the engine oil filter cap , be sure to check that the engine oil filter spring and the "O" ring are installed correctly. Use new "O" ring each time the engine oil filter element is replaced. Replace the oil filter cap and tighten the nuts securely but do not over tighten them. 37 9. Approximately 3, 200 of oil will be required. ENGINE COOLANT COOLANT LEVEL CAUTION Approximately 3, 000 of oil must be required when changing oil only without replacing the oil filter. CAUTION In case of the engine oil pouring excessively, the engine output being made insufficient. Confirm the oil level with the oil level lens after waiting about a minute next to stopping the engine. The oil level is located between the "Lower line(L)" and the "Upper line(F)". When below the "Lower line(L)", refill the oil between the "Lower line(L)" and the "Upper line(F)". The coolant should be kept between the "F"(FULL) and "L"(LOW) level lines in the reservoir tank at all times. Inspect the level every time before riding while the motorcycle vertically. If the coolant is found lower than the "L" level line, add properly mixed coolant in the following way : If the reservoir tank is emptied, pour the engine coolant to the reservoir tank and radiator. Remove the filler cap and add properly mixed coolant through the filler hole until it reaches the "F" line. Refer to the FUEL, ENGINE OIL AND COOLANT RECOMMENDATION section (13 page). 38 WARNING Engine coolant is harmful or fatal if swallowed or inhaled. If coolant gets in eyes, flush eyes with water and seek medical attention. Keep out of the reach of children and aminals. OPEN THE RADIATOR CAP Remove the right front side cover to operate the radiator cap . To disassemble the right front side cover , remove the two mounting bolts . WARNING You can be injured by scalding fluid or steam if you open the radiator cap when the engine is hot. After the engine cools, wrap a thick cloth around cap and carefully remove the cap by turning it a quarter to allow pressure to escape and then turn the cap all the way off. NOTE Adding only water will dilute the engine coolant and reduce its effectiveness. Add 50 : 50 mixture of engine coolant and water. CHANGING THE COOLANT Change the coolant every two years. NOTE About 1. 6 of coolant will be required when filling the radiator and reservoir tank. 39 RIDING TIPS STARTING THE ENGINE Necessary attempt before start the engine : 1. [. . . ] 15A head lamp fuse protects the head lamp and high beam indicator lamp. CAUTION Never use other than specified 30A or 15A fuse. Installing a fuse of incorrect rating may seriously damage the electrical system. You should consult your Hyosung dealer or a qualified service mechanic immediately. 66 WHEN THE ENGINE REFUSES TO START TROUBLE SHOOTING If the engine refuses to start, perform the following inspections to determine the cause. Ignition System Check Remove a spark plug and reattach to the spark lead. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE HYOSUNG GV 650 EFI




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual HYOSUNG GV 650 EFI will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.