User manual JBL AS SUB

[. . . ] AS Series Owner's Manual 9/11/98 12:51 PM Page 1 AS5, AS6, AS8, AS65C & AS SUB simple set-up guide thank you for choosing JBL. For over 50 years, JBL has been involved in every aspect of musical and film recording and reproduction, from live performances to monitoring the recordings you play in your home, car, or office. [. . . ] Then connect the left satellite to the left output and the right satellite to the right output. Subwoofer Left Satellite Left Right Right Satellite ­+ Output Input ­+ ­+ ­+ ­+ Output Input ­+ ­+ LEFT ­+ RIGHT Note: Diagram is for illustrative purposes. For each channel it does not matter which pair of connectors is used for the input or which pair is used for the output. Receiver/Amplifier AS Series Owner's Manual 9/11/98 12:51 PM Page 4 three. Installation The AS Series in-wall speakers were designed to be easily installed. However, if you are unsure of your ability to properly install these loudspeakers, please contact your dealer or a qualified installer. Tools Needed Phillips #2 screwdriver Measuring tape Utility knife Pencil Carpenter's level Awl AS5, AS6, AS8 Installation Kit Template Speaker frame Thread-forming screws Retainer clips Four mounting brackets Short phillips head screws AS Series Owner's Manual 9/11/98 12:51 PM Page 5 Existing Construction Level 1-1/2" 1-1/2" 1-1/2" Template Tape Step One: Remove the grille from the speaker frame. Step Two: Determine the correct speaker location. Step Three: Determine the speaker-frame location. Kerf Line Step Four: Cut the dry wall. Step Five: Place the mounting bracket on the speaker frame using the mounting guides (marked 3/8" , 1/2" 5/8" and 3/4") corre, , sponding to the thickness of the dry wall. Step Six: Place the frame assembly in the wall. Step Seven: Connect the speaker wires to the baffle assembly and install baffle assembly in frame. Do not overtighten the baffle screws. Step Eight: Replace the metal grille. AS Series Owner's Manual 9/11/98 12:51 PM Page 6 New Construction 1-1/2" 1-1/2" 1-1/2" Step One: Remove the grille from the speaker frame. Step Two: Determine the correct speaker location. Step Three: Attach the proper mounting brackets, marked and preset at 3/8" 1/2" 5/8" and 3/4" corre, , , , sponding to the thickness of the dry wall, to the speaker frame. Step Four: Nail or screw the speaker-frame assembly to the wall studs and route the wires through the frame opening. After the Drywall is Installed Step Five: Cut the drywall. Step Six: Connect the speaker wires to the baffle assembly and install baffle assembly in frame. Do not overtighten the baffle screws. Step Seven: Replace the metal grille. AS Series Owner's Manual 9/11/98 12:51 PM Page 7 AS SUB 1-1/2" 1-1/2" 1-1/2" Step One: Remove the grille from the subwoofer frame. Step Two: Determine the correct subwoofer location. Step Three: Cut the drywall. Step Four: Loosen the eight phillips head screws until the locking tabs turn inward. Step Five: Connect the speaker wires to the baffle assembly. Step Six: Place the subwoofer in the wall. Step Seven: Screw down each of the eight phillips head screws. The tabs will swivel into place and secure the unit to the rear surface of the drywall. Step Eight: Replace the metal grille. AS Series Owner's Manual 9/11/98 12:51 PM Page 8 AS65C 1-1/2" 1-1/2" 1-1/2" Step One: Remove the grille from the speaker frame. Step Two: Determine the correct speaker location. Step Three: Cut the drywall. Step Four: Connect the speaker wires to the speaker. Step Five: Loosen the three phillips head screws on the frame until the locking tabs turn inward. Step Six: Place the frame assembly in the wall. Step Seven: Screw down each of the three phillips head screws. The tabs will swivel into place and secure the unit to the rear surface of the drywall. Step Eight: Replace the metal grille. AS Series Owner's Manual 9/11/98 12:51 PM Page 9 Painting the Speaker Frame and Grille AS Series loudspeakers can be painted to match any style of decor. If you wish to change their color, the satin finish on the grille and frame will function as a primer coat. Before painting, install the paint guard (in the assembly kit) securely into the recess in the baffle. [. . . ] We do not recommend sustained operation at these maximum power levels. ** Mounting depth. AS Series Owner's Manual 9/11/98 12:51 PM Page 12 Declaration of Conformity We, JBL Europe A/S Kongevejen 194B DK-3460 Birkerød DENMARK declare in own responsibility, that the loudspeakers described in this owner's manual are in compliance JBL Consumer Products 80 Crossways Park West, Woodbury, NY 11797 8500 Balboa Boulevard, Northridge, CA 91329 1-800-336-4JBL (4525) (USA only) www. jbl. com 1996 JBL, Incorporated. ASOM with technical standards: EN 50 081-1/1992 EN 50 082-1/3. 1995 © A Harman International Company Steen Michaelsen JBL Europe A/S Birkerød. [. . . ]