User manual JBL ATX 60

[. . . ] X + 0 + Y 2 0 M HZ OWNER'S GUIDE PRODUCT LINE: ATX Series MODEL NUMBER: ATX20/30/40/60/10C/100S (230V) DESIGN GOAL: Bring the thrill of live performance and movie sound to the home environment by calling on JBL's professional engineering leadership. PROFESSIONAL REFERENCE: Home Loudspeaker Series THANK YOU FOR CHOOSING JBL For more than 50 years, JBL has been involved in every aspect of music and film recording and reproduction, from live performances to the recordings you play in your home, car or office. We're confident that the JBL system you have chosen will provide every note of enjoyment that you expected ­ and that when you think about purchasing additional audio equipment for your home, car or office, you will once again choose JBL. JBL Consumer Products READ THIS! CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: To prevent electric shock, do not remove the grounding plug on the power cord, or use any plug or extension cord that does not have a grounding plug provided. [. . . ] If a replacement cord is used, make certain that it is of a similar gauge. As with all electrical devices, do not run power cords under rugs or carpets or place heavy objects on power cords. Damaged power cords should be replaced immediately, by a qualified service technician, with cords meeting factory specifications. When disconnecting the power cord from an AC outlet, always pull the plug; never pull the cord. 23. The power cord of the product should be unplugged from the outlet when left unused for long periods of time. For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. Do not overload wall outlets, extension cords, or integral convenience receptacles, as this can result in a risk of fire or electric shock. Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a. Objects have fallen, or liquid has been spilled into, the product; or c. The product does not operate normally when following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation; or e. The product does not appear to operate normally or exhibits a marked change in performance. 27. Never push objects of any kind into this product through openings, as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. The product should be situated away from heat sources such as radiators, heat registers, stoves or other products (including amplifiers) that produce heat. Avoid installation in extremely hot or cold locations, in an area that is exposed to direct sunlight or near heating equipment. When positioning the product in its final location, make certain that it has adequate ventilation on all sides, as well as on the top and bottom. Declaration of Conformity We, Harman Consumer International 2, route de Tours 72500 Château-du-Loir France declare in own responsibility, that the product described in this owner's manual is in compliance with technical standards: EN 60065:1998 EN 55013/A14:1999 EN 55020/A14:1999 EN 61000-3-2/A14:2000 EN 61000-3-3/1. 1995 EN 50081-1:1992 EN 50082-1:1992 Gary Mardell JBL, Harman Consumer International France, 03/02 3 SPEAKER PLACEMENT Front Speakers Center Channel Speaker Subwoofer 0 ­ 0. 61m (0 ­ 2 ft. ) Surround Speakers 1. 52 ­ 1. 83m (5 ­ 6 ft. ) Placement ATX Series loudspeakers are designed to give very good performance in a wide variety of placements. Best results, however, will be obtained when the speakers are placed on a strong and sturdy stand at a little distance from walls and corners. Placement in corners will increase the amount of bass, which can result in a "heavy" or "boomy" sound. If such placement is unavoidable, it is recommended that you use the tone control on the amplifier or receiver to reduce the bass. [. . . ] · Check all wires and connections between receiver/amplifier and speakers. If there is no sound coming from one speaker: · Check the "Balance" control on your receiver/amplifier. · Check all wires and connections between receiver/amplifier and speakers. · In Dolby Digital or DTS® modes, make sure that the receiver/processor is configured so that the speaker in question is enabled. [. . . ]