User manual JBL BALBOA 10 (220-240V)

[. . . ] SPEAKER PLACEMENT Proper placement of the speakers is an important step in obtaining the most realistic soundstage possible. These recommendations are for the optimal placement of the loudspeakers. All of the Balboa Series loudspeakers referred to in this guide are video-shielded MODEL: BALBOA 30 and can safely be placed near a television. MODEL: BALBOA 10 As front speakers As surround speakers Placement for surround back speakers in 6. 1/7. 1 systems, or alternate placement for side surround speakers in 5. 1 systems. MODEL: BALBOA CENTER The Balboa Center loudspeaker is designed to complement all of the Balboa Series loudspeakers. [. . . ] To use the binding-post speaker terminals, unscrew the colored collar until the pass-through hole in the center post is visible. Insert the bare end of the wire through this hole; then screw the collar down until the connection is tight. The hole in the center of each collar is intended for use with banana-type connectors. To comply with European CE certification, these holes are blocked with plastic inserts at the point of manufacture. Do not remove these inserts if you are using the product in an area covered by the European CE certification. MODELS: BALBOA 10 AND BALBOA 30 RIGHT LEFT ­ + ­ + ­+ RIGHT ­ + LEFT Receiver's Speaker Outputs MODEL: BALBOA CENTER ­ ­ + + CENTER Receiver Speaker Outputs TROUBLESHOOTING If there is no sound from any of the speakers: · Check that receiver/amplifier is on and that a source is playing. If there is no sound coming from one speaker: · Check the "Balance" control on your receiver/amplifier. · Check all wires and connections between receiver/ amplifier and speakers. · Make sure no wires are touching other wires or terminals and creating a short circuit. · In Dolby* Digital or DTS® modes, make sure that the receiver/processor is configured so that the speaker in question is enabled. · Turn off all electronics and switch the speaker in question with one of the other speakers that is working correctly. Turn everything back on, and determine whether the problem has followed the speaker, or has remained in the same channel. If the problem is in the same channel, the source of the problem is most likely with your receiver or amplifier, and you should consult the owner's manual for that product for further information. If the problem has followed the speaker, consult your dealer for further assistance or, if that is not possible, visit www. jbl. com for further information. If the system plays at low volumes but shuts off as volume is increased: · Check all wires and connections between receiver/ amplifier and speakers. · If more than one pair of main speakers is being used, check the minimum impedance requirements of your receiver/ amplifier. If there is no (or low) bass output: · Make sure the polarities (+ and ­) of the left and right "Speaker Inputs" are connected properly. [. . . ] · Review the operation of your DVD player and the jacket of your DVD to make sure that the DVD features the desired Dolby Digital or DTS mode, and that you have properly selected that mode using both the DVD player's menu and the DVD disc's menu. Declaration of Conformity We, Harman Consumer Group International 2, route de Tours 72500 Chateau-du-Loir France declare in own responsibility that the products described in this owner's manual are in compliance with technical standards: EN 61000-6-3:2001 EN 61000-6-1:2001 Gary Mardell Harman Consumer Group International Chateau-du-Loir, France 1/05 English SPECIFICATIONS BALBOA 10 Description 2-Way 130mm (5") bookshelf Maximum Recommended Amplifier Power** 125W Power Handling (Continuous/Peak) 60W/240W Nominal Impedance 8 Ohms Sensitivity (2. 83V/1m) 86dB Frequency Response (­3dB) 68Hz ­ 20kHz Crossover Frequency 3000Hz High-Frequency Transducer 19mm (3/4") Titanium-laminate dome Low-Frequency Transducer 130mm (5") Pure-cellulose fiber cone, shielded Baffle Low diffraction, IsoPowerTM Port FreeFlowTM flared Network Straight-Line Signal PathTM (SSP) Terminal 5-Way binding posts Dimensions (H x W x D) (With grille) 259mm x 165mm x 210mm Weight per Speaker 3. 9kg BALBOA 30 Description 3-Way 170mm (6") floorstanding Maximum Recommended Amplifier Power** 150W Power Handling (Continuous/Peak) 80W/320W Nominal Impedance 8 Ohms Sensitivity (2. 83V/1m) 90dB Frequency Response (­3dB) 47Hz ­ 20kHz Crossover Frequencies 600Hz, 3500Hz High-Frequency Transducer 19mm (3/4") Titanium-laminate dome Midrange Transducer 100mm (4") Pure-cellulose-fiber cone, shielded Low-Frequency Transducer 170mm (6") Pure-cellulose-fiber cone, shielded Baffle Low diffraction, IsoPowerTM Port FreeFlowTM flared Network Straight-Line Signal PathTM (SSP) Terminals 5-Way binding posts Dimensions (H x W x D) (With grille and feet) 889mm x 229mm x 321mm Weight per Speaker 14. 5kg BALBOA CENTER Description 2-Way dual 130mm (5") center Maximum Recommended Amplifier Power** 150W Power Handling (Continuous/Peak) 75W/300W Nominal Impedance 8 Ohms Sensitivity (2. 83V/1m) 90dB Frequency Response (­3dB) 80Hz ­ 20kHz Crossover Frequency 3500Hz High-Frequency Transducer 19mm (3/4") Titanium-laminate dome, shielded Low-Frequency Transducer Dual 130mm (5") Pure-cellulose fiber cone, shielded Baffle Low diffraction, IsoPowerTM Port FreeFlowTM flared Network Straight-Line Signal PathTM (SSP) Terminals 5-Way binding posts Dimensions (H x W x D) (With grille) 170mm x 479mm x 260mm Weight per Speaker 6. 9kg PRO SOUND COMES HOMETM JBL Consumer Products, 250 Crossways Park Drive, Woodbury, NY 11797 8500 Balboa Boulevard, Northridge, CA 91329 2, route de Tours, 72500 Chateau-du-Loir, France 516. 255. 4JBL (4525) www. jbl. com © 2005 Harman International Industries, Incorporated JBL is a registered trademark, and IsoPower, FreeFlow and Straight-Line Signal Path are trademarks, of Harman International Industries, Incorporated. ** The maximum recommended amplifier power rating will ensure proper system headroom to allow for occasional peaks. We do not recommend sustained operation at these maximum power levels. [. . . ]