User manual JBL CONTROLNOW

[. . . ] Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. When positioning, or moving this product ensure that is lifted rather than dragged across any floor/mounting surface. Products and/or product feet constructed of rubber or plastics may, in seldom cases, react chemically and discolor treated or non-treated wooden surfaces if positioned without protection. Warranty: The following conditions may result in a void product warranty: a. [. . . ] Damage to mechanical parts (such as record-/playback heads, moving rubber and plastic parts and fuses) as well as results of normal wear and tear. Damage caused by excessive electrical mains supply voltage or lightning strike. Damage caused by professional employment of home entertainment products (e. g. for catering trade, restaurants, public address or infinite loop announcement use etc. ) 17. Specifications: All product specifications/features are subject to change without notification. Amplifiers: Amplifiers used to drive these units must deliver a sufficient output power. A lack of output power may lead to amplifier-clipping, which causes damage not covered by guarantee. Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating, and these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer's instructions have been adhered to. Make certain that the proper space (more than 10cm) is provided both above and below the unit for ventilation. Objects have fallen, or liquid has been spilled into, the product; or c. The product does not operate normally when following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation; or e. The product does not appear to operate normally or exhibits a marked change in performance. 27. Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage or other hazards. Never push objects of any kind into this product through openings, as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. The product should be situated away from heat sources such as radiators, heat registers, stoves or other products (including amplifiers) that produce heat. Avoid installation in extremely hot or cold locations, in an area that is exposed to direct sunlight or near heating equipment. When positioning the product in its final location, make certain that it has adequate ventilation on all sides, as well as on the top and bottom. English CONTROLNOW Bracket assembly and mounting: English Important safety note: Proper selection of mounting hardware not included herein and proper assembly and installation of brackets, including but not limited to selection of appropriate weight bearing support and bracket use with the specified speaker only is the exclusive responsibility of the customer. Manufacturer disclaims any liability for the selection of mounting hardware and or bracket installation. [. . . ] If the bracket needs to be mounted on drywall, the use of properly selected and installed wall-anchors and screws is essential. Make sure that the screw head is at least 0. 36 inches (approximately 3/8 inches) or larger in diameter so that it can properly hold the backup cord eyelet /. Holding the speaker cabinet ¶ with both hands, reinsert the ball portion of the ball/shaft £ into the wall bracket ¢. Hand tighten the molded nut TM while positioning the speaker for the intended orientation. [. . . ]