User manual JBL E 90 (220-240V)

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JBL E 90 (220-240V). We hope that this JBL E 90 (220-240V) user guide will be useful to you.


JBL E 90 (220-240V) : Download the complete user guide (274 Ko)

You may also download the following manuals related to this product:

   JBL E 90 (220-240V) (69 ko)
   JBL E 90 (220-240V) (67 ko)
   JBL E 90 (220-240V) (70 ko)
   JBL E 90 (220-240V) (262 ko)
   JBL E 90 (220-240V) (281 ko)
   JBL E 90 (220-240V) (220 ko)
   JBL E 90 (220-240V) (68 ko)
   JBL E 90 (220-240V) (239 ko)
   JBL E 90 (220-240V) (69 ko)

Manual abstract: user guide JBL E 90 (220-240V)

Detailed instructions for use are in the User's Guide.

[. . . ] MODELS: E60, E80, E90, E100 MODELS: E30, E50 As front speakers As surround speakers 5 ­ 6 ft. (1. 5m­1. 8m) MODEL: EC35 (0­0, 6m) The EC35 center channel loudspeaker is designed to complement all of the Northridge E Series loudspeakers. It is the ideal way to re-create the cinematic experience in your home. ® NORTHRIDGE E SERIES E30, E50, E60, E80, E90, E100, EC35 TM OWNER'S GUIDE SPEAKER CONNECTIONS The hole in the center of each collar is intended for use with banana-type connectors. [. . . ] If this is a concern, these speakers should be anchored to the wall behind them, using the same procedures and hardware customary for anchoring bookcases and wall units. The customer is responsible for proper installation and proper selection of hardware. CENTER Receiver Speaker Outputs Speakers and electronics terminals have corresponding (+) and (­) terminals. It is important to connect both speakers identically: (+) on the speaker to (+) on the amplifier and (­) on the speaker to (­) on the amplifier. Wiring "out of phase" results in thin sound, weak bass and poor imaging. To use the binding-post speaker terminals, unscrew the colored collar until the pass-through hole in the center post is visible. Insert the bare end of the wire through this hole; then screw the collar down until the connection is tight. High Frequency ­ + ­ + Low Frequency ­ + Amplifier Bi-Wire Connections TROUBLESHOOTING If there is no sound from any of the speakers: If the system plays at low volumes but shuts off as volume is increased: If there is no sound from the surround speakers: · Check that receiver/amplifier is on and that a source is playing. · Review proper operation of your receiver/amplifier. If there is no sound coming from one speaker: · Check all wires and connections between receiver/ amplifier and speakers. · If more than one pair of main speakers is being used, check the minimum impedance requirements of your receiver/amplifier. If there is no (or low) bass output: · Check all wires and connections between receiver/ amplifier and speakers. · Review proper operation of your receiver/amplifier and its surround sound features. · Make sure the movie or TV show you are watching is recorded in a surround sound mode. If it is not, check to see whether your receiver/ amplifier has other surround modes you may use. · In Dolby Digital or DTS modes, make sure your receiver/processor is configured so that the surround speakers are enabled. · Review the operation of your DVD player and the jacket of your DVD to make sure that the DVD features the desired Dolby Digital or DTS mode, and that you have properly selected that mode using both the DVD player's menu and the DVD disc's menu. · Check the "Balance" control on your receiver/ amplifier. · Check all wires and connections between receiver/ amplifier and speakers. · Make sure no wires are touching other wires or terminals and creating a short circuit. · In Dolby* Digital or DTS® modes, make sure that the receiver/processor is configured so that the speaker in question is enabled. [. . . ] Recommended Amplifier Power** 175W Power Handling (Continuous/Peak) 90W/360W Nominal Impedance 8 Ohms Sensitivity (2. 83V/1m) 90dB Frequency Response (­3dB) 45Hz ­ 20kHz Crossover Frequencies 800Hz, 3200Hz High-Frequency Transducer 19mm Titaniumlaminate dome, shielded Midrange Transducer 100mm PolyPlas, TM shielded Low-Frequency Transducer 200mm PolyPlas, TM shielded Baffle Low diffraction, IsoPowerTM Max. Recommended Amplifier Power** 175W Power Handling (Continuous/Peak) 90W/360W Nominal Impedance 8 Ohms Sensitivity (2. 83V/1m) 90dB Frequency Response (­3dB) 40Hz ­ 20kHz Crossover Frequencies 1000Hz, 4000Hz High-Frequency Transducer 19mm Titaniumlaminate dome, shielded Max. Recommended Amplifier Power** 125W Power Handling (Continuous/Peak) 70W/280W Nominal Impedance 8 Ohms Sensitivity (2. 83V/1m) 88dB Frequency Response (­3dB) 50Hz ­ 20kHz Crossover Frequency 4000Hz High-Frequency Transducer 19mm Titaniumlaminate dome, shielded Midrange Transducer NA Low-Frequency Transducer 170mm PolyPlas, TM shielded Baffle Low diffraction, IsoPowerTM Port FreeFlowTM flared Network Straight-Line Signal PathTM (SSP) Midrange Transducer Midrange Transducer 100mm PolyPlas, TM 100mm PolyPlas, TM shielded shielded Low-Frequency Transducer 200mm PolyPlas, TM shielded Baffle Low diffraction, IsoPowerTM Low-Frequency Transducers Dual 170mm PolyPlas, TM shielded Baffle Low diffraction, IsoPowerTM Port FreeFlowTM flared Network Straight-Line Signal PathTM (SSP) Midrange Transducer Midrange Transducer 100mm PolyPlas, TM 75mm PolyPlas, TM shielded shielded Low-Frequency Low-Frequency Transducers Transducers Dual 250mm PolyPlas, TM Dual 133mm PolyPlas, TM shielded shielded Baffle Low diffraction, IsoPowerTM Port FreeFlowTM flared Network Straight-Line Signal PathTM (SSP) Baffle Low diffraction, IsoPowerTM Port FreeFlowTM flared Network Straight-Line Signal PathTM (SSP) Ports Port Dual FreeFlowTM flared FreeFlowTM flared Network Straight-Line Signal PathTM (SSP) Network Straight-Line Signal PathTM (SSP) Terminals Terminals Terminals Terminals Terminals Terminals Terminals Gold-plated, 5-way Gold-plated, 5-way Gold-plated, 5-way Gold-plated, 5-way Gold-plated, 5-way Gold-plated, 5-way Gold-plated, 5-way binding posts, bi-wirable binding posts, bi-wirable binding posts, bi-wirable binding posts, bi-wirable binding posts, bi-wirable binding posts, bi-wirable binding posts, bi-wirable Dimensions (H x W x D) Dimensions (H x W x D) Dimensions (H x W x D) Dimensions (H x W x D) Dimensions (H x W x D) Dimensions (H x W x D) Dimensions (H x W x D) 381mm x 213mm x 305mm 292mm x 445mm x 311mm 927mm x 251mm x 305mm 927mmx 213mm x 343mm 1022mm x 251mm x 368mm 1067mm x 311mm x 368mm185mm x 558mm x 264mm Weight Per Speaker 16. 3 lb/7. 4kg Weight Per Speaker 25 lb/11. 4kg Weight Per Speaker 35 lb/15. 9kg Weight Per Speaker 40 lb/18. 2kg Weight Per Speaker 48 lb/21. 8kg Weight Per Speaker 55 lb/25kg Weight Per Speaker 22 lb/10kg PRO SOUND COMES HOMETM JBL Consumer Products, 250 Crossways Park Drive, Woodbury, NY 11797 8500 Balboa Boulevard, Northridge, CA 91329 2, route de Tours, 72500 Chateau-du-Loir, France 516. 255. 4JBL (4525) www. jbl. com © 2003 Harman International Industries, Incorporated JBL is a registered trademark of Harman International Industries, Incorporated. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE JBL E 90 (220-240V)




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JBL E 90 (220-240V) will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.