User manual JBL E10

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JBL E10. We hope that this JBL E10 user guide will be useful to you.


JBL E10 : Download the complete user guide (80 Ko)

Manual abstract: user guide JBL E10

Detailed instructions for use are in the User's Guide.

[. . . ] (1. 5­1. 8m) The EC25 center channel loudspeaker is designed to complement all of the Northridge E Series loudspeakers. It is the ideal way to re-create the cinematic experience in your home. As surround speakers MODELS: E10, E20, EC25 The supplied self-adhesive speakers to protect your rubber feet may be attached furniture. [. . . ] Check that the loudspeaker is firmly locked onto the screws by gently pulling the speaker down and forward. · Proper selection of mounting hardware and installation of the wall brackets are the responsibility of the customer. Two Number 8 round head or pan head screws should be used per loudspeaker. The screw head should be between 5/16 inch (8mm) and 1/4 inch (6. 3mm) in diameter, and the screw should be at least 2 inches (50mm) in length. When installing screws in any wall, always use properly selected wall anchors. Attach two of the four self-adhesive rubber pads that came with the E10 loudspeaker to the back of the enclosure in the two bottom corners so that the cabinet is spaced evenly from the wall. (The ceiling is not a suitable mounting location. ) Drill two pilot holes, appropriately sized for the specific self-tapping screw or wall anchor that you will be using. The holes should be 3/4" (19mm) below where you want the top of the enclosure to be positioned. Use a carpenter's level to ensure that the holes are even and that the speaker will mount on the level. Install the two screws into either a wooden wall stud or 8" (203mm) 1/8" (3mm) TROUBLESHOOTING If there is no sound from any of the speakers: · Check that receiver/amplifier is on and that a source is playing. · Review proper operation of your receiver/amplifier. If there is no sound coming from one speaker: · Check the "Balance" control on your receiver/amplifier. · Check all wires and connections between receiver/amplifier and speakers. Make sure no wires are touching other wires or terminals and creating a short circuit. [. . . ] · In Dolby Digital or DTS mode, make sure your receiver/processor is configured so that the surround speakers are enabled. · Review the operation of your DVD player and the jacket of your DVD to make sure that the DVD features the desired Dolby Digital or DTS mode, and that you have properly selected that mode using both the DVD player's menu and the DVD disc's menu. SPECIFICATIONS E10 Description 2-Way 4" wall-mount/bookshelf Maximum Recommended Amplifier Power** 100W Power Handling (Continuous/Peak) 50W/200W Nominal Impedance 8 Ohms Sensitivity (2. 83V/1m) 86dB Frequency Response (­3dB) 75Hz ­ 20kHz Crossover Frequency 2000Hz High-Frequency Transducer 3/4" (19mm) Titanium-laminate dome, shielded Low-Frequency Transducer 4" (100mm) PolyPlas, TM shielded Baffle Low diffraction, IsoPowerTM Port FreeFlowTM flared Network Straight-Line Signal PathTM (SSP) Terminals Gold-plated, 5-way binding posts Dimensions (H x W x D) 10" x 10-1/8" x 5-1/4" 254mm x 257mm x 133mm Weight Per Speaker 8 lb/3. 6kg Declaration of Conformity E20 Description 2-Way 5" bookshelf Maximum Recommended Amplifier Power** 125W Power Handling (Continuous/Peak) 60W/240W Nominal Impedance 8 Ohms Sensitivity (2. 83V/1m) 86dB Frequency Response (­3dB) 68Hz ­ 20kHz Crossover Frequency 3000Hz High-Frequency Transducer 3/4" (19mm) Titanium-laminate dome Low-Frequency Transducer 5" (130mm) PolyPlas, TM shielded Baffle Low diffraction, IsoPowerTM Port FreeFlowTM flared Network Straight-Line Signal PathTM (SSP) Terminals Gold-plated, 5-way binding posts Dimensions (H x W x D) 10-7/8" x 6" x 8-1/8" 275mm x 153mm x 206mm Weight Per Speaker 7 lb/3. 2kg EC25 Description 2-Way dual 5" center Maximum Recommended Amplifier Power** 150W Power Handling (Continuous/Peak) 75W/300W Nominal Impedance 8 Ohms Sensitivity (2. 83V/1m) 90dB Frequency Response (­3dB) 80Hz ­ 20kHz Crossover Frequency 4000Hz High-Frequency Transducer 3/4" (19mm) Titanium-laminate dome, shielded Low-Frequency Transducer Dual 5" (130mm) PolyPlas, TM shielded Baffle Low diffraction, IsoPowerTM Port FreeFlowTM flared Network Straight-Line Signal PathTM (SSP) Terminals Gold-plated, 5-way binding posts Dimensions (H x W x D) 6-7/8" x 18" x 10" 175mm x 457mm x 254mm Weight Per Speaker 15. 6 lb/7. 1kg We, Harman Consumer International 2, route de Tours 72500 Chateau-du-Loir France declare in own responsibility, that the products described in this owner's manual are in compliance with technical standards: EN 50081-1:1992 EN 50082-1:1997 Gary Mardell Harman Consumer International Chateau-du-Loir, France 2/03 PRO SOUND COMES HOMETM JBL Consumer Products, 250 Crossways Park Drive, Woodbury, NY 11797 8500 Balboa Boulevard, Northridge, CA 91329 2, route de Tours, 72500 Chateau-du-Loir, France 800. 336. 4JBL (4525) (USA only) www. jbl. com © 2003 Harman International Industries, Incorporated JBL is a registered trademark of Harman International Industries, Incorporated. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE JBL E10




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JBL E10 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.