User manual JBL E80CH
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JBL E80CH. We hope that this JBL E80CH user guide will be useful to you.
Manual abstract: user guide JBL E80CH
Detailed instructions for use are in the User's Guide.
[. . . ] Do not remove these inserts if you are using the product in an area covered by the European CE certification. BI-WIRING The bi-wire connection method requires one amplifier and two sets of speaker wires. By removing the shorting bars, connections may be made to the individual network sections using four conductors, one for each of the four terminals. [. . . ] By removing the shorting bars, connections may be made to the individual network sections using four conductors, one for each of the four terminals. For single-wire connection, leave the shorting bars in place and connect only a single set of speaker wires (two conductors) to the two upper terminals.
MODELS: E30, EC35, E50
MODELS: E30, E50, E60, E80, E90, E100
RIGHT LEFT
The supplied self-adhesive rubber feet may be attached to the bottom corners of your speakers to protect your furniture.
MODELS: E60, E80, E90, E100
+
+
+
RIGHT
+
LEFT
Receiver's Speaker Outputs
MODEL: EC35
CENTER
+
+
These models feature four rubber feet that enable them to be placed on a smoothsurfaced floor, such as tile or hardwood. Four metal spikes are supplied for use when the speaker is to be placed on a carpeted surface, to decouple the speaker from the floor and prevent unwanted damping. To insert the spikes, gently lay the speaker on its side (not its front or back) on a soft, nonabrasive surface. Each spike screws into the threaded insert in the center of each rubber foot. NEVER drag the speaker to move it, as this will damage the spikes, the feet and/or the wood cabinet itself. CAUTION: Floorstanding (tower) loudspeakers have a high center of gravity and may become unstable and tip over during earthquakes, or if rocked, tipped or improperly positioned. If this is a concern, these speakers should be anchored to the wall behind them, using the same procedures and hardware customary for anchoring bookcases and wall units. · In Dolby* Digital or DTS® modes, make sure that the receiver/processor is configured so that the speaker in question is enabled. · Turn off all electronics and switch the speaker in question with one of the other speakers that is working correctly. Turn everything back on, and determine whether the problem has followed the speakers, or has remained in the same channel. If the problem is in the same channel, the source of the problem is most likely with your receiver or amplifier, and you should consult the owner's manual for that product for further information. If the problem has followed the speaker, consult your dealer for further assistance or, if that is not possible, visit www. jbl. com for further information.
· Make sure the polarities (+ and ) of the left and right "Speaker Inputs" are connected properly. · Consider adding a powered subwoofer to your system for use with digital ". 1" surround formats.
Declaration of Conformity
We, Harman Consumer International 2, route de Tours 72500 Chateau-du-Loir France declare in own responsibility that the products described in this owner's manual are in compliance with technical standards: EN 50081-1:1992 EN 50082-1:1997 Gary Mardell Harman Consumer International Chateau-du-Loir, France 7/03
SPECIFICATIONS
E30
Description 2-Way 6" bookshelf
E50
E60
E80
Description 3-Way dual 6" floorstanding
E90
Description 3-Way dual 8" floorstanding Max. Recommended Amplifier Power** 225W Power Handling (Continuous/Peak) 110W/440W Nominal Impedance 8 Ohms Sensitivity (2. 83V/1m) 91dB Frequency Response (3dB) 36Hz 20kHz Crossover Frequencies 300Hz, 4000Hz High-Frequency Transducer 3/4" (19mm) Titaniumlaminate dome, shielded
E100
Description 3-Way dual 10" floorstanding
EC35
Description 3-Way dual 5" center
Description Description 3-Way, 8" 3-Way 8" horizontal/vertical floorstanding mirror-image bookshelf Max. Recommended Amplifier Power** 175W Power Handling (Continuous/Peak) 90W/360W Nominal Impedance 8 Ohms
Max. [. . . ] · Consider adding a powered subwoofer to your system for use with digital ". 1" surround formats.
Declaration of Conformity
We, Harman Consumer International 2, route de Tours 72500 Chateau-du-Loir France declare in own responsibility that the products described in this owner's manual are in compliance with technical standards: EN 50081-1:1992 EN 50082-1:1997 Gary Mardell Harman Consumer International Chateau-du-Loir, France 7/03
SPECIFICATIONS
E30
Description 2-Way 6" bookshelf
E50
E60
E80
Description 3-Way dual 6" floorstanding
E90
Description 3-Way dual 8" floorstanding Max. Recommended Amplifier Power** 225W Power Handling (Continuous/Peak) 110W/440W Nominal Impedance 8 Ohms Sensitivity (2. 83V/1m) 91dB Frequency Response (3dB) 36Hz 20kHz Crossover Frequencies 300Hz, 4000Hz High-Frequency Transducer 3/4" (19mm) Titaniumlaminate dome, shielded
E100
Description 3-Way dual 10" floorstanding
EC35
Description 3-Way dual 5" center
Description Description 3-Way, 8" 3-Way 8" horizontal/vertical floorstanding mirror-image bookshelf Max. Recommended Amplifier Power** 175W Power Handling (Continuous/Peak) 90W/360W Nominal Impedance 8 Ohms
Max. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE JBL E80CH
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JBL E80CH will begin.