User manual JBL GT5-803

[. . . ] If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and builtup static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. [. . . ] Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation; or e. The product exhibits a distinct change in performance ­ this indicates a need for service. When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. The product should be mounted to a wall or ceiling only as recommended by the manufacturer. The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. 1. All the safety and operating instructions should be read before the product is operated. The safety and operating instructions should be retained for future reference. All warnings on the product and in the operating instructions should be adhered to. Do not use attachments not recommended by the product manufacturer, as they may cause hazards. length in either white or black. Remote control. features · Dolby* Pro Logic* Processor with additional Phantom, Simulated, 3-Stereo, and Stereo Surround modes. · Six channels of amplification for all speakers and subwoofer. · Five identical, 2-way micro-satellites with titanium tweeters. · Remote sensor with connection wire for easy placement. one. Speaker Placement Satellites Subwoofer 0-2 ft. Mounting Remote Sensor to Center Speaker. If desired, the remote sensor may be placed anywhere using the supplied double-sided tape. Center speaker. Place remote sensor at bottom of center speaker. Insert support leg through remote sensor and into speaker. Surround Speakers 5 ­ 6 ft. Mounting Options Satellites and Surrounds On shelves. On the wall. FS300 or FS300WHT (white). Surround Modes Dolby Pro Logic Use this mode for films recorded using Dolby Pro Logic Surround. The center channel is not used and the surround channels have a 20-ms delay. Simulated This mode provides surround sound with no delay for the surround speakers. 3-Stereo Mode Use this mode to play back Pro Logic-encoded films when you do not want the surround channels to play. Stereo This mode plays a recording in traditional two-channel stereo. Test Tone The test tone is used to calibrate the volume settings of the speakers. A static noise will be heard cycling, in order, from the front left, center, right, and both surround speakers. [. . . ] "Dolby, " "Pro Logic" and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation. Speaker and Amplifier Connection three. Press (­) to decrease the level of low-frequency information. 10­14. Surround Modes From the remote, press one of these buttons to directly choose the desired surround mode (see "Surround Modes" section). From the front panel, press (Surround Mode) to cycle between the surround modes. [. . . ]