User manual JBL JBL 5101B SCHEMATIC

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and then on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment to a different outlet so that the equipment and receiver are on different branch circuits. [. . . ] Changes or modifications not expressly approved by JBL could void the user's authority to operate the equipment. Please Read the Following Operation Precautions Before Use Read instructions ­ All safety and operating instructions should be read thoroughly before attempting to operate this audio system. Heed warnings ­ All warnings on this audio system and in the operating instructions should be adhered to. ⷠFollow instructions­ All operating and use instructions should be followed. Do not drop, apply excessive force to the controls, or put heavy objects on top of the speaker. In order to protect the speaker system, avoid microphone feedback, continuous output from electronic musical instruments, or distorted output from any signal source Do not place the speakers close to fluorescent light sources or neon light fixtures. Although the speakers are magnetically shielded, keep magnetic storage media (disks and tapes) at least four inches from the speaker system in order to avoid data loss. To Turn Pairing On Press the Pairing switch on the bottom of the JBL on stageTM* II unit by inserting a paper clip or similar device. Then press any button on the Remote within 5 seconds to associate that particular remote with the unit. To Turn Pairing Off Press the Pairing switch on the bottom of the JBL on stageTM* II unit by inserting a paper clip or similar device. After about 5 seconds, the unit will respond to any JBL on stageTM* II remote control. Pairing Button Troubleshooting If JBL on stageTM* II is not responding to the remote's commands, check for the following possible problems and solutions. Solution Possible Problem Ensure that the correct power supply is No power to the connected to JBL on stageTM* II. Ensure system that the power button is pushed inward and the green LED is lighted. [. . . ] Solution Possible Problem Ensure that the correct power supply is No power to the connected to JBL on stageTM* II. Ensure system that the power button is pushed inward and the green LED is lighted. Ensure the side Hold switch is in the Remote switch in a position that prevents the orange dot lock position from being visible. [. . . ]