User manual JBL ON STAGE 200ID

[. . . ] No naked flame sources, such as lighted candles, should be placed on or near the apparatus. Attention should be drawn to the environmental aspects of battery disposal. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatuses (including amplifiers) that produce heat. [. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · · · Reorient the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Any special accessories needed for compliance must be specified in the instruction manual. MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT UNDER FCC RULES. CAUTION RISK OF ELECTRIC SHOCK -- DO NOT OPEN THE LIGHTNING FLASH AND ARROWHEAD WITHIN THE TRIANGLE IS A WARNING SIGN ALERTING YOU TO DANGEROUS VOLTAGE INSIDE THE PRODUCT. CAUTION: TO REDUCE THE RISK OF SHOCK, DO NOT REMOVE COVER. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. THE EXCLAMATION POINT WITHIN THE TRIANGLE IS A WARNING SIGN ALERTING YOU TO IMPORTANT INSTRUCTIONS ACCOMPANYING THE PRODUCT. WARNING: TO PREVENT FIRE OR ELECTRICAL SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. WARNING: THE APPARATUS SHOULD NOT BE EXPOSED TO DRIPPING OR SPLASHING AND NO OBJECTS FILLED WITH LIQUID, SUCH AS VASES, SHOULD BE PLACED ON THE APPARATUS. IMPORTANT: THE APPROPRIATE ADAPTER MUST BE INSTALLED BEFORE INSERTING YOUR iPod/iPhone INTO THE JBL® PRODUCT. MAKE SURE THAT THE CONNECTOR FOR THE iPod/iPhone IS PROPERLY ALIGNED WITH THE JBL PRODUCT'S CONNECTOR WHEN INSTALLING YOUR iPod/iPhone. FAILURE TO DO SO MAY CAUSE PERMANENT DAMAGE TO THE CONNECTOR FOR THE iPod/iPhone, RENDERING THE iPod/iPhone INOPERABLE. WWW. JBL. COM 3 English UNPACKING YOUR JBL ON STAGE * 200ID TM IR remote JBL JBL On StageTM* 200ID Adapters for iPod/iPhone MENU Power supply Audio cable QUICK SETUP INSTRUCTIONS · · · Plug the barrel end of the power supply cord into the power jack and plug the other end into the wall. Next, push the power switch; a green LED will light up, indicating that the unit is powered. Auxiliary port (for other portable audio devices): Connect the included audio cable from this port into the headphone jack of your portable audio device. REAR VIEW Power switch Power Auxiliary port AUX IN DC 12V Power jack JBL AUX IN Power DC 12V Find the correct adapter for your iPod/iPhone, then firmly place it into the docking area shown. Next, place your iPod/iPhone into the dock, making sure your iPod/iPhone is firmly seated. Press either button to unmute. 4 JBL ON STAGE 200ID USER GUIDE SPECIFICATIONS JBL ON STAGETM* 200ID TROUBLESHOOTING Symptom Possible Problem No power to the system. [. . . ] iPod et iTunes sont des marques commerciales de Apple Inc. , déposées aux États-Unis et dans d'autres pays. « Made for iPod » signifie qu'un accessoire électronique a été conçu pour ce connecter spécifiquement à l'iPod et que sa conformité aux normes de performances Apple a été certifiée par son constructeur. « Works with iPhone » signifie que le dispositif électronique a été spécialement conçu pour se connecter à l'iPhone et qu'il est certifié par le développeur comme conforme aux normes de performance Apple. [. . . ]