User manual JBL JBL ON STAGE II

[. . . ] Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Radio and Television Interference This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Volume Up Music Browsing Before proceeding, make sure the iPod® is docked into the JBL on stageTM* II and the remote Hold Switch is in a position so that the orange dot is not visible. Turn iPod® On: Turn iPod® Off: Play a Track: Pause a Track: Skip to Next Track: Skip to Previous Track: Fast Advance Track: Fast Reverse Track: Increase Volume: Decrease Volume: Lock Remote Buttons: Press any button on the remote control to wake the iPod®. Note: If the iPod® is at the Main Menu, button while a song is playing. Pressing Play/Pause will cause the iPod® to start playing all of its music. Photo Browsing (iPod® in photo browsing mode) The JBL on stageTM* II remote control can be used to browse images on your iPod® Photo player. To do so, the remote control needs to be in the Photo Mode by following two steps listed below: 1. The remote is ready to browse photos forward or backward by pressing the Volume Up and Volume Down buttons, respectively. To exit Photo mode, slide the Hold switch from Active to Hold, then back to Active. If you have any questions, or need further assistance, please visit www. " If more than one JBL on stageTM* II Remote control is within range of the speaker unit, multiple remotes would be able to control the speaker unit. [. . . ] Battery Replacement The JBL on stageTM* II remote's battery should last a year under normal usage. To replace the battery, open the remote control unit by removing the three small screws in the back of the remote, and replace the old battery with a CR2032 type battery or equivalent. [. . . ]