User manual JBL LC2

[. . . ] Although these loudspeakers are designed as a mirrored pair, the decision as to which one is left or right will depend on the amount of space left between them. For stereo-only applications: Less than 1, 8m-2, 4m (6-8 feet) A wider stereo image is presented with the tweeter/ midrange array outboard, and a tighter image is presented with the array inboard. Less than 1, 8m-2, 4m (6-8 feet) For home theater applications: 0-0, 6m (0-2ft) This placement provides a wide spread in sound, supplemented by the center channel speaker. MODELS: LC1, LC2 The LC1 and LC2 center channel loudspeakers are designed to complement all of the Studio L Series loudspeakers. Either speaker is ideal for re-creating the cinematic experience in your home. 3 English SPEAKER CONNECTIONS Speakers and electronics have corresponding (+) and (­) terminals. [. . . ] Always lift the speaker and carry it to its new location. Place pads here Place pads here 4 CAUTION: Floorstanding (tower) loudspeakers have a high center of gravity and may become unstable and tip over during earthquakes, or if rocked, tipped or improperly positioned. If this is a concern, these speakers should be anchored to the wall behind them, using the same procedures and hardware customary for anchoring bookcases and wall units. The customer is responsible for proper installation and proper selection of hardware. WALL-MOUNTING (Models L810, L820, LC2) Important Safety Notes · Proper selection of mounting hardware and installation of the wall brackets are the responsibility of the customer. Two Number 8 round-head or pan-head screws should be used for each loudspeaker. The screw head should be between 5/16 inch (8mm) and 1/4 inch (6. 3mm) in diameter, and the screw should be at least 2 inches (50mm) in length. When installing screws in any wall, it is always preferable to screw them into a wall stud. If none is available, it is important to always use properly selected wall anchors. Attach two of the four selfadhesive rubber pads that came with the loudspeaker to the back of the enclosure in the two bottom corners so that the cabinet is spaced evenly from the wall. (The ceiling is not a suitable mounting location. ) Drill two pilot holes, appropriately sized for the specific self-tapping screw or wall anchor that you will be using. A template is included with your loudspeaker that indicates the proper locations for the pilot holes. In the event that the template is missing, refer to this chart: Model L810 L820 LC2 Distance Between Pilot Holes 152mm (6") 216mm (8-1/2") 368mm (14-1/2") See Figure 1. The holes should be 57mm below where you want the top of the enclosure to be positioned. [. . . ] · Consider adding a powered subwoofer to your system for use with digital ". 1" surround formats. We, Harman Consumer Group International 2, route de Tours 72500 Chateau-du-Loir France declare in own responsibility that the products described in this owner's manual are in compliance with technical standards: EN 61000-6-3:2001 EN 61000-6-1:2001 Laurent Rault Harman Consumer Group International Chateau-du-Loir, France 4/05 PRO SOUND COMES HOMETM JBL Consumer Products, 250 Crossways Park Drive, Woodbury, NY 11797 USA 8500 Balboa Boulevard, Northridge, CA 91329 USA, phone 516-255-4JBL (USA only) 2, route de Tours, 72500 Chateau-du-Loir, France www. jbl. com © 2005 Harman International Industries, Incorporated. JBL is a registered trademark of Harman International Industries, Incorporated. [. . . ]