User manual JBL MUSIC 10

[. . . ] Owner's Manual TM T h a n k s for choosing the SoundEffects M u s ic10 system for your home. Combine them any way you like to achieve the sound effects you envision. [. . . ] The Bass10 subwoofer has been designed to simplify connection of your Music10 system to your amplifier/ receiver. Connect the left and right speaker outputs of your amplifier to the appropriate "Amplifier Inputs" on the Bass10. Then connect the Satellite outputs to the left and right Sat10s. Separate and strip the ends of the speaker wire as shown. Some receivers/amplifiers have a separate connection for a subwoofer. JBL assumes no responsibility or liability for injuries or property damage ­ direct, indirect, or consequential ­ resulting from the improper installation of SoundEffects loudspeakers. Speakers and electronics terminals have corresponding (+) and (­) terminals. It is important to connect both speakers identically: (+) red speaker to (+) red amplifier and (­) black speaker to (­) black amplifier. Wiring "out of phase" results in thin sound, weak bass and poor stereo effect. The two wires in any speaker cable are typically differentiated in one of the following ways: one wire is copper and the other silver, or one has a raised rib or a thin colored line on its insulated cover and the other doesn't. Either wire can attach to (+) or (­) as long as all components are connected identically. F i n a l l y. Take a "test drive" with some favorite music. 1 With the receiver/amplifier still turned off, confirm that its volume control is turned all the way down. If the receiver/amplifier has an A/B speaker switch, set it to correspond to the speaker terminals connected to the Music10 system. 2 Now, turn on your receiver/amplifier and select a music source such as a CD player, cassette deck or FM tuner. 3 Turn up the volume control gently until you hear sound from the speakers. If the sound comes from the right speaker with the balance control to the left, the speaker wires have been reversed during hookup. [. . . ] SoundEffects M o v i e s10 will help you get even more value from your M u s i c 10 system. For information about these and other SoundEffects products, visit your JBL dealer or, in the USA call 800-336-4JBL. Specifications Features · 2-Way satellite speakers with 3/4" Music10 System Power Handling 10 ­ 200 watts Frequency Response 40Hz ­ 20kHz (±3dB) titanium composite dome high frequency drivers · Triple chamber band-pass subwoofer · Adjustable satellites with shelf stands included Sat10 Power Handling 10 ­ 80 watts Frequency Response 150Hz ­ 20kHz (±3dB) Impedance 8 ohms nominal Sensitivity 88dB @ 1 watt / 1 meter Crossover Frequency 3. 5kHz (midrange to tweeter) Tweeter One 3/4" titanium composite dome Video-shielded Midrange One 3-1/2" neodymium driver Video-shielded Dimensions (HxWxD) Inches 6 -1/2 x 3 -3/4 x 4 -1/4 Millimeters 165 x 95 x 108 Weight 1. 5 lbs / . 7 kg · Video-shielded satellites · Recessed wire channels on both satellites · Diffraction-limiting foam satellite baffles Refinements may be made on occasion to existing products without notice, but will always meet or exceed original specifications unless otherwise stated. Bass10 Power Handling 10 ­ 120 watts Frequency Response 40Hz ­ 150Hz (±3dB) Impedance 8 ohms nominal Sensitivity 88dB @ 1 watt / 1 meter Crossover Frequency 150Hz (subwoofer to satellite) Bass Two 5-1/4" woofers Triple chamber band-pass subwoofer Dimensions (HxWxD) Inches 14-3/4 x 8-1/2 x 19 Millimeters 375 x 216 x 465 Weight 28 lbs / 12. 7 kg TM JBL Consumer Products, Inc. , 80 Crossways Park West, Woodbury, NY 11797. [. . . ]