User manual JBL N CENTER II

[. . . ] S P E C I F I C AT I O N S N24II Description: 2-Way 4" bookshelf, plastic N24AWII 2-Way 4" bookshelf, plastic, weather-resistant Maximum Recommended Amplifier Power:** Nominal Impedance: Sensitivity (2. 83V/1m): Frequency Response (­3dB): Crossover Frequency: High-Frequency Transducer: Low-Frequency Transducer: N26AWII 2-Way 6" bookshelf, plastic, weather-resistant N-CENTERII 2-Way dual 5" center 100W 8 Ohms 86dB 75Hz ­ 20kHz 3000Hz 3/4" Titanium-laminate dome, shielded (not shielded on model N24AWII) 4" PolyPlas, TM shielded (Model N24AWII uses an unshielded WeatherPlasTM woofer) Dark gray (N24II) Off-white (N24AWII) Gray cloth (N24II) Off-white mesh (N24AWII) 9-1/2" x 6-1/4" x 4-3/4" 241mm x 159mm x 121mm 4. 5 lb/2. 1kg 125W 8 Ohms 88dB 55Hz ­ 20kHz 3000Hz 3/4" Titanium-laminate dome 150W 8 Ohms 90dB 80Hz ­ 20kHz 3500Hz 3/4" Titanium-laminate dome, shielded 6" WeatherPlasTM Dual 5" PolyPlas, TM shielded Finish: Grille Color: Dimensions (H x W x D): Weight Per Speaker: Off-white Off-white mesh Dark gray Gray cloth 14-1/2" x 10-3/4" x 7-3/4" 368mm x 273mm x 197mm 8. 3 lb/3. 8kg 6-1/2" x 20-1/2" x 8-1/2" 165mm x 521mm x 216mm 10 lb/4. 6kg * Trademarks of Dolby Laboratories. ** The maximum recommended amplifier power rating will ensure proper system headroom to allow for occasional peaks. [. . . ] It is important to connect both speakers identically: (+) on the speaker to (+) on the amplifier and (­) on the speaker to (­) on the amplifier. Wiring "out of phase" results in thin sound, weak bass and a poor stereo image. With the advent of multichannel surround sound systems, connecting all of the speakers in your system with the correct polarity remains equally important in order to preserve the proper ambience and directionality of the program material. To use the binding-post speaker terminals, unscrew the colored collar until the pass-through hole in the center post is visible under the collar. Insert the bare end of the wire through this hole; then screw the collar down until the connection is tight. The hole in the center of each collar is intended for use with bananatype connectors. MODELS: N24II, N24AWII, N26AWII RIGHT LEFT MODEL: N-CENTERII CENTER ­ ­ + ­ + + ­+ ­ + ­ + CENTER Receiver Speaker Outputs Receiver Speaker Outputs WALL-MOUNTING MODELS: N24II, N24AWII, N26AWII Vertical Horizontal The Northridge Series speaker models indicated above may be wall-mounted. The customer is responsible for proper selection and use of mounting hardware, available through hardware stores, to properly and safely wall-mount the speakers. Adjustable wall-mounting brackets are included with models N24II and N24AWII. Optional, adjustable, wall-mounting brackets are available from JBL for model N26AWII. Contact your dealer, or call 800-336-4JBL for a dealer near you, and order model no. WBN26WHT. TROUBLESHOOTING If there is no sound from any of the speakers: · Check that receiver/amplifier is on and that a source is playing. If there is no sound coming from one speaker: · Check the "Balance" control on your receiver/amplifier. [. . . ] · If your receiver/processor is set in Dolby Pro Logic* mode, make sure the center speaker is not in phantom mode. · If your receiver/processor is set in Dolby Digital or DTS mode, make sure the receiver/ processor is configured so that the center speaker is enabled. [. . . ]