User manual JBL ON STAGE MICRO III

[. . . ] To completely disconnect this apparatus from the AC mains, disconnect the power supply cord plug from the AC receptacle. The mains plug of the power supply cord shall remain readily operable. Do not expose batteries to excessive heat such as sunshine, fire or the like. [. . . ] · If you are using conventional batteries, make sure that all of them are fresh. · Do not use a combination of rechargeable and conventional batteries. · The Status LED will illuminate amber when the batteries need to be replaced. Replace the battery door and rotate it to the locked position. * * AC outlet adapter varies by region. MENU 2. Rotate the battery door to the unlocked position and remove it. · Do not mix battery types. Observe the battery polarity that is indicated inside the battery compartment. cAutIoN: Risk of explosion of battery if replaced with incorrect type. Connect a USB Type Mini-B cable (not included) to the JBL On Stage Micro III's USB port and to a USB port on the computer on which your iTunes is located. ImpoRtANt: If you play audio through a docked ipod/iphone and an audio source connected to the Audio In connection at the same time, you will hear both of their outputs mixed through the JBl on stage micro III. to hear only one source you will need to manually turn off the source you do not want to hear. Insert the included AC outlet adapter all the way into the power supply (if there is more than one adapter, use the correct one for your region). Then connect the power supply into the JBL On Stage Micro III's 6V DC In connector and plug it into an AC wall outlet. If you are going to use your JBL On Stage Micro III with another audio source, plug one end of a 3. 5mm stereo cable (not included) into the Audio In connector, and plug the other end into the audio source's audio out or headphone out connector. 3. 5mm 4 8. Place the appropriate iPod/iPhone adapter into the JBL On Stage Micro III's iPod well and place your iPod/iPhone on the docking connector. Make sure the iPod/iPhone is inserted all the way onto the connector. 9. [. . . ] · BLOnStageMicroIIIisintheenergyconservationmode(nosoundwasdetected J for at least 10 minutes). No sound (white led is illuminated): · ouchtheVolumeUp(+)buttontoincreasethesystemvolume. T ·fyou'reusingadockediPod/iPhone, makesurethatitisproperlydockedintheJBL I On Stage Micro III. ·fyou'reusinganauxiliarysource, makesurethattheaudiocableisproperly I connected to the JBL On Stage Micro III's Audio In connector and to the source component's audio output. [. . . ]