User manual JBL OS-400P

[. . . ] To be completely disconnected from the power input, the main plug of the AC/DC adapter shall be disconnected from the main. The main plug of the AC/DC adapter should not be obstructed OR should be easily accessed during intended use. The battery shall not be exposed to excessive heat such as sunshine, fire or the like. [. . . ] using the Navigation controls , browse songs and photos , change tracks and settings , and more. With the JBL On Stage 400P remote, you have complete control of your iPod/iPhone, as though it were in your hand. EVERCHARGE TOPOLOGY The unit charges your iPod/iPhone, even when not connected to the computer or when the system is off. The clean and compact digital amplification, coupled with DSP (digital signal processing) equalization, efficiently provides the transducers with cool-running power. 6 JBL ON STAGE 400P USER GUIDE UNPACKING YOUR JBL ON STAGE™* 400P Carefully unpack your speaker system and identify all its components: JBL MENU JBL On Stage™* 400P Adapters for iPhone and iPod IR remote Power supply Audio cable QUICK SETUP INSTRUCTIONS • • • • • Plug the barrel end of the power supply cord into the power jack and plug the other end into the wall. Next, push the power switch; a green LED will light up, indicating that the unit is powered. Find the correct adapter for your iPod iPod/iPhone, then firmly place it into the docking area shown. , Next, place your iPod iPod/iPhone into the dock, making sure your iPod iPod/iPhone is firmly seated. COM 7 English SPECIFICATIONS JBL ON STAGE™* 400P Frequency Response: 40Hz – 20kHz Power Consumption: 55 Watts maximum JBL On Stage 400P Transducers: One Atlas™ (45mm) neodymium and four Odyssey® (25mm) Power: 1 x 30 Watts (woofer) 2 x 15 Watts (tweeters), at 1% THD Input Impedance: >10k Ohms Signal-to-Noise Ratio: >85dB Input Sensitivity: 250mV RMS for rated power output Power (USA/Canada): 120 Volts, 60Hz AC Power (Europe/UK): 220 – 240 Volts, 50Hz or 60Hz AC Power (Japan): 100 Volts, 50Hz or 60Hz AC Power (Australia): 240 Volts, 50Hz or 60Hz AC UL/CUL/CE-Approved Dimensions: 14-1/4" x 7-3/16" x 3-3/4" (W x D x H) (362mm x 183mm x 95mm) Weight: 3. Power Supply Model: 700-0084 TROUBLESHOOTING SOUND QUALITY Symptom No sound from the JBL On Stage 400P unit. Make sure all switches for the outlet/power strip are on and that all switches for the speaker system are on. If not, power is not getting to your JBL On Stage 400P system; try the solutions shown. Make sure the iPod/iPhone is properly docked or that the auxilary cable is properly connected to an external audio device. Connect the Auxiliary Port cable to the headphone jack on your iPod/iPhone. Make sure the iPod/iPhone or Auxiliary Port cable is seated all the way into the JBL On Stage 400P unit. Noise may be caused by interference from a monitor, cell phone or other transmitting device. [. . . ] €Works with iPhone” means that an electronic accessory has been designed to connect specifically to iPhone and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. IPhone och iPod är inte inklusive ”Made for iPod” betyder att ett elektroniskt tillbehör har designats speciellt för att anslutas till iPod/iPhone och har certifierats av tillverkaren för att möta Apple´s standards för prestanda. [. . . ]