User manual JBL REFERENCE 610

[. . . ] Headphone/earphone listening at high volume levels may cause permanent damage to your hearing. Always set the volume control to the lowest level before switching to different sources (tuner, CD player, MP3 player, etc. For your safety, do not use headphones/earphones while driving or cycling. These headphones incorporate 60 years of JBL's professional audio experience and technology, setting a new standard for Bluetooth® wireless headphone systems. [. . . ] A Bluetooth device with both A2DP and AVRCP (Audio/Video Remote Control Profile) will stream music and allow functionality of the "Music Playing Mode" control features. Make sure headphone power is "Off" and transceiver is disconnected from the iPod. Turn headphone power back "On" and wait for solid LED, then three quick flashes ­ indicating that the headphone system is in "discoverable" mode. To pair your Bluetooth-enabled device to the headphones, please refer to your user's manual for the proper setup procedure. When your audio device requests a passcode to pair with the JBL Reference Series 610 headphone system, enter the numerical sequence "0000". Note: The headphone control features may be limited when used with devices other than your iPod, due to the varying designs and possible remote control limitations of your audio device. The volume "_" and "+" buttons are controlled by pressing to make your selection. If you do not notice a change in the volume, make sure your iPod does not have a low battery. Located on the four-position toggle switch are: _( ) "menu" (push once to take you to menu mode) _ (<<) "previous track" (push once), "fast rewind" (press and hold) _ (>>) "next track" (push once), "fast forward" (push and hold) _ (>) "play/pause" (press once to play, once to pause) For situations when you are not able to use your Bluetooth wireless mode to stream music, the JBL Reference Series 610 headphones can be connected to your audio device through the included audio cable. Make sure the volume on your audio device is turned to the minimum position, to ensure hearing safety, prior to connecting your headphones. Plug the mini USB connector on your audio cable into the headphone charging port. The control features buttons will not be functional when the headphone system is used with the audio cable. Menu mode brings up a second tier of iPod navigation features, which let you roam through your iPod menus. To scroll "up" (<<) or "down" (>>) the menu, hold down the proper feature button until you reach your selection. To make a selection from the menu list, push and hold the menu button ( ). In the menu mode, pressing and holding play/pause ">" allows you to turn your iPod on or off remotely from your headphones. Symptom when used with Bluetooth transceiver Possible Problem Solution Note Symptom when used with Bluetooth transceiver Headphone controls have intermittent operation. If blue LED on headphones continues to blink rapidly after headphone system has paired, it is indicating a low battery. [. . . ] Disconnect transceiver from iPod and turn headphone power "Off", then back "On". Charge headphones by following If blue LED on headphones the battery charging directions in continues to blink rapidly after this User Guide. A monotone will also be sounded every 5 seconds for low battery alert. JBL Reference Series 610 White/Black with Chrome 96dB SPL/mW @ 1kHz iPod Dongle connected to iPod models 4th generation and above Bluetooth A2DP and AVRCP profile streaming Two 40mm neodymium drivers 2 x 50mW maximum power 20Hz ­ 20kHz (­10dB) Diameter ­ 102mm, hardwire audio cable ­ 1. [. . . ]