User manual JBL WBN26WHT

[. . . ] inches) or larger in diameter so that it can properly hold the backup cord eyelet (15). Northridge Series WBN26 Bracket assembly and mounting: IMPORTANT SAFETY NOTE: PROPER SELECTION OF MOUNTING HARDWARE NOT INCLUDED HEREIN AND PROPER ASSEMBLY AND INSTALLATION OF BRACKETS, INCLUDING BUT NOT LIMITED TO SELECTION OF APPROPRIATE WEIGHT BEARING SUPPORT AND BRACKET USE WITH THE SPECIFIED SPEAKER ONLY IS THE EXCLUSIVE RESPONSIBILITY OF THE CUSTOMER. MANUFACTURER DISCLAIMS ANY LIABILITY FOR THE SELECTION OF MOUNTING HARDWARE AND/OR BRACKET INSTALLATION. [. . . ] The back-up cord (13) is provided as an additional measure to prevent the fall of the speaker in the event the speaker becomes detached from the wall bracket. The remaining bracket-to-housing bolt (12) (bolts 11 and 12 are identical) will need to go through the eyelet (14) (eyelets 14 and 15 are also the same) at the end of the cord before going through the housing (10). Using a suitable screwdriver, tighten this bolt (12) also to the speaker housing (10). Using the wall bracket (16) as a template, mark the screw locations for where the unit is to be mounted. The wall bracket (16) is to be mounted onto a wood stud on the wall, using #12, minimum 1 inch long, pan head wood screws. Make sure that all 4 screws are driven into the stud and not in drywall. If the bracket needs to be mounted on drywall, the use of properly selected and installed wall-anchors and screws is essential. Make sure that the screw head is at least 0. 41 inches (approximately 7/16 g. Fully insert the threaded portion (3) of the `thin' end of the ball/shaft (2) into the center opening (17) of the wall bracket (16), with the wall bracket middle area towards the threaded portion (3). Engage, and using a suitable wrench, securely tighten the split washer (18) and the nut (19), with the split washer (18) sandwiched between the area on the back of the wall bracket (16) and the nut (19). Mount the wall bracket (16) onto the wall, using three of the four #12 screws (20) (not supplied), while following the recommendations in item (f) above. Two of the three screws should be used in the top two holes of the mounting bracket. [. . . ] Double-check and make sure both nuts (4 and 5) are fully tightened and that the speaker is stable on the bracket. The two nuts (4 and 5) should now be fully locked into position, and completely tightened against each other. [. . . ]