User manual JENSEN JIMS-198I

[. . . ] DOCKING MUSIC SYSTEM FOR iPod® and iPhoneTM ALARM 1 FM STEREO ALARM 2 PM OWNER'S MANUAL JiMS-198i (iPod/iPhone Not Included) PLEASE READ THIS OPERATING MANUAL COMPLETELY BEFORE OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE. DEAR JENSEN® CUSTOMER Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. Now it's time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association's Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level. One that lets the sound come through loud and clear without annoying blaring or distortion and, most importantly, without affecting your sensitive hearing. [. . . ] To play your iPod, insert the adaptor included with your iPod into the docking bay area. To play your iPhone, insert the included adaptor into the docking bay area. Your iPod / iPhone can now be docked by placing the connector on the bottom of the iPod / iPhone onto the connector in the docking bay. Excessive force or pressure can damaging the 30-pin connector on iPod or on the docking system. Use the right iPhone adaptor (2G or 3G) before plugging in your iPhone. Press the FUNCTION button to select " iPod " mode, "IPod" shows on LED display and the system will start playback automatically. Note: The volume level cannot be adjusted using the volume control on your iPod / iPhone after being docked. To remove the iPod / iPhone from the unit, press and hold the PLAY/PAUSE button for five seconds to switch off the device and then gently remove ot form the docking connector. When playing your iPhone, playback will be suspended if there is an incoming call, the iPhone will ring. Touch the Answer icon on your iPhone once to pick up the call, touch the Speaker button once to answer the call in handsfree mode, press the End Call Icon when you have finished your call. To enhance sound quality in handsfree mode, you should always use the dock adaptor when docking the iPhone. CHARGING When an iPod or iPhone is docked in the docking bay it will be charged in all function modes. SHUFFLE : Press the "SHUFFLE/PRESET-" button to play music from your iPod or iPhone randomly. REPEAT: Press the "REPEAT/PRESET+" button to repeat a single track or repeat all tracks from your iPod or iPhone. To prevent damaging the dock connector, never twist the iPod / iPhone when inserting or removing it. Make sure the connector in the dock is lined up with the connector on the iPod before attaching. Be careful not to knock over the iPod when it is inserted in the dock. 12 USING HEADPHONES (NOT INCLUDED) Insert the plug of your headphones (not included) into the Headphone jack, on the back of the unit and you can now listen in private. When using headphones, the speakers will be disconnected automatically. Avoid extended play at very high volume as it may impair your hearing. If you experience ringing in your ears, reduce the volume or shut off your unit. Keep the volume at a reasonable level even if your headset is an open-air type designed to allow you to hear outside sounds. [. . . ] In this event, unplug and then reconnect the AC power plug into the wall outlet. Use a straightened paper clip, toothpick or similar objects to press the RESET button located on the side of the main unit (see the below figure). The reset operation clears the system memory and all of your previous settings will be erased. IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT. RESET 17 TROUBLESHOOTING GUIDE Symptom Possible Problem AC Adaptor is not plugged into a wall outlet or the connector is not plugged into the power supply jack on the back of the unit. [. . . ]