User manual JUNO ELZG 1480 SP ELT EBH

[. . . ] Specialised companies that are qualified to do so by the manufacturer must carry out service and repairs including repairing and changing the power cord. Otherwise the appliance can be damaged or can cause other damage or injury. The appliance is out of circuit only in that case if the plug is removed from the socket. Before cleaning and maintenance always unplug it (do not get it by the cable). [. . . ] Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction. Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. Wait 4 hours before connecting the appliance to allow the oil to flow back in the compressor. Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. The temperature regulator allows you to adjust the temperature inside the refrigerator according to use and external conditions. The following effects are of significance in respect of the interior temperature: ambient temperature quantity and temperature of the food stored; frequency with which the door is opened and how long it is left open the location of the appliance. To permit storage of food packages of various sizes, the shelves can be placed at different heights. To remove the internal shelf pull forward until it can be tipped up or down and removed. please do the same in reverse to insert the shelf at a different height. after defrosting the thermostatic control restarts operation of the system. Melting water flows through defrost water outlet into the evaporative tray maintained on the top of compressor and evaporates due to warmth of it. Check and clean the outlet of melting water coming during defrosting regularly. Foods do not spoil if the appliance is full and the cutoff lasts a short time (see further information under "Preservation time in case of failure" in the catalogue or advertising material). If the power cutoff continues, eat the thawed foods within a short time. The internal temperature is influenced by the following factors: - Room temperature - How often the door is opened - Amount of food products stored - Appliance setting Caution: Check the state of the frozen foods if the freezer compartment heats up. Can cause earlier failure as it can go to the insulating of the appliance. Clean the melting water outlet with the supplied pipe scraper that can be seen in the figure. The most typical case of clogging up in the defrost water outlet when you put food wrapped in some paper into the appliance and this paper contacts back plate of fresh food compartment and freezes to it. If you remove the food right at this moment the paper will tear and it can cause clogging up in the outlet by getting into it. So you are asked to be careful - because of the above - when placing foods wrapped in paper into the appliance. [. . . ] Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. During normal operation, the condenser and compressor at the back Attention: keep ventilation openings clear of obstruction. It is necessary that the niche is provided with a conduct of ventilation having the following dimensions: Depth 50 mm Width 540 mm The climate classification can be found on the rating plate, which is located inside the cabinet on the left hand wall. The following table shows which ambient temperature is correct for each climate classification: It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. [. . . ]