Detailed instructions for use are in the User's Guide.
[. . . ] . page 56
ENGLISH
TECHNICAL SPECIFICATIONS
DIMENSIONS Width Height Max depth Max depth with door open 59, 6 cm 81, 8 ÷ 87, 8 cm 57, 5 cm 115 cm
ELECTRICAL CONNECTION POWER OF HEATING ELEMENT OVERALL POWER
Voltage
220-230 V/50Hz 2800 W 3000 W
WATER SUPPLY PRESSURE
minimum maximum
5 N/cm2 80 N/cm2 12
CAPACITY (STANDARD IEC PLACE SETTINGS)
CONSUMPTION:
Water Electricity
22 lt 1. 5 kW/h
This appliance complies with the following E. E. C. Directives: - 73/23 of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications.
PID03GB
44
WARNINGS
It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. You MUST read them carefully before installing or using the appliance.
s s
Under no circumstances should you attempt to repair the machine yourself. [. . . ] Important Salt MUST be used regularly from level 2 upward.
Filling with Salt
Only use salt designed specifically for use in dishwashers. Other types of salt contain high percentages of other substances which may reduce the efficiency of the softener. Fill the container with 1 litre of water (this operation is necessary only the first time). Place approximately 1, 5 ÷ 1, 8 kg of dishwasher salt inside using the funnel provided (see figure).
LE SA LT SA LZ SA L SE
ENGLISH
0- 7 8-21 22-28 29-39 40-50
0-14 15-39 40-50 51-70 71-90
1 *2 3 4 5
**NO YES YES YES YES
NO NO YES NO YES
NO NO NO YES YES
* The water softener is factory set at level 2 as this suits most users. ** If you use phosphate free detergents containing enzymes, use salt starting
from 4°dH (7°TH).
Level 1 If your water is «level 1» it is already soft and therefore there is no need to use salt. Levels 3 and 5 (water softener adjustment) If your water is level 3 or 5, proceed as follows: slide out the lower basket and unscrew the cap of the salt container; turn the twoposition selector anticlockwise from position - to position + with the aid of a knife or a screwdriver.
AA02
SR05
Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket. When this has been done, all that is required is to periodically add salt to the container.
You are reminded of this by a green refill indicator on the cap of the salt container. When the green indicator disappears, the water softener needs refilling with salt. The salt container has always some water inside which will normally overflow when refilling with salt. Caution Only fill with salt just before starting one of the complete washing programmes (not Rinse and Hold programme). This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine for any period of time. Care must be taken when opening the door, as steam will escape.
PCL04GB
51
ENGLISH
Washing programmes
Recommended quantity of detergent
Programmes Required Starting pushposition button of the programmer
in the dispenser on the door on the dispenser lid
1/2
Cycle description
Approximate consumption values
***
Type of load
Degree of soil
Energy Water Programme consumption consumption duration in kWh in litres in minutes
* Normal
Programme 65°
Normally or heavily soiled, also dried up and/or containing starch (i. e. pasta, rice, semolina, potatoes, egg, sauces, roast).
3
(20 g) (5 g) 2 dessert spoons (25 g)
2 level dessert spoons dessert spoon Cold prewash Main wash up to 65°C 1 cold rinse 1 hot rinse up to 65°C Hot air drying
64
1, 5
22
Normal Programme without prewash 65°
Pots - Pans Lightly soiled, even dried up Crockery and containing starch (i. e. pasta, rice, semolina, potatoes, egg, sauces, roast).
4 /
Main wash up to 65°C 2 cold rinses 1 hot rinse up to 65°C Hot air drying
58
1, 5
18
PTP03GB
52
** Quick
Crockery, cutlery
Programme 65°
Lightly soiled, not dried up (i. e. Due to the shortness of this programme, no drying phase is provided.
1
(15 g)
1 heaped dessert spoon
/ /
Main wash up to 65°C 1 cold rinse 1 hot rinse up to 65°C
44
1, 4
18
Rinse & Hold
Partial load to be completed later. This programme does not require any detergent.
2
/
1 cold rinse (to avoid food scraps from sticking to the crockery).
10
0, 1
14
*
This programme is equivalent to IEC 436/DIN44990. Recommended quantity of detergent: 20 g in the dispenser 5 g over the dispenser lid Standard place settings: 12
** This is a special programme for quick washing (approx. 44 minutes) a full load of lightly soiled dishes, glasses and crockery (except pots) so that you may re-use them promptly. Due to the shortness of this programme, no drying phase is provided.
These *** also onspecifications are indicative values and depend on the pressure and temperature of the water, and voltage modification.
Operating Sequence 1 Check that the filters are clean
(see cleaning instructions)
6 Start the programme
Insert the plug into the wall socket. The «mains on» indicator light will come on and the machine will start.
2 Check that there is salt and rinse aid
If you wish to interrupt the wash at any time press button again. To restart the machine, depress the same button again and the programme will continue from the point where it was interrupted.
3 Load the dishes
Remove larger scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. [. . . ] The washing programme selected is too gentle.
Original spare parts can be purchased from Service Centres.
Protection against flooding
In order to prevent water floods, the machine has been provided with two additional devices, having the following characteristics: 1. In the water inlet hose (see water connection): the device comes into operation as a result of any damage to the water inlet hose and stops the water inflow. In the bottom of the machine: the device comes into operation as a result of any water leaks in the machine and it functions only with the machine on. To repair the machine, call the Service Centre.
s
s s s
s s
Visible lime deposits or white film on the dishes
s
The rinse aid has run out or too little is being used.
PRA15GB
55
ENGLISH
BUILDING-IN
Building-in features
This dishwasher is designed to be fitted under a kitchen counter or sink. [. . . ]