User manual KENWOOD CM470

[. . . ] This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions. before plugging in Make sure your electricity supply is the same as the one shown on the underside of your machine. key water filter water filter holder removable water tank lid compartment for excess cord hotplate (model CM470 series only) anti drip activating device program button clock button on/off button with indicator light glass carafe and lid (model CM470 series only) thermal carafe and lid (model CM480 series only) measuring spoon filter holder permanent coffee filter (or use a paper filter instead) lid opening lip aroma control cup storage area to make coffee 1 Lift the lid. 3 Separate the water filter holder by pulling the unit apart and place the water filter inside. [. . . ] CM480 series To achieve the best performance, rinse the thermal carafe with hot water immediately before switching on the coffee maker. For brewing, the lid should be fully closed with the tab on the lid in line with the carafe handle. The on/off button will glow and the coffee maker will start to operate. The back light of the display will come on and automatically switch off after 10 minutes. The back light of the display will come on for one minute and then go off automatically. 14 Don't remove the carafe until brewing has finished. CM470 series The hot plate will keep your coffee hot, but the sooner you drink it, the better it will taste. Your coffee maker will keep the coffee warm and then automatically switch off after 2 hours. CM480 series To pour coffee after brewing has finished, unscrew the lid 180° so that the tab on the lid is in line with the pouring spout. Once the desired amount of coffee has been poured, screw the lid back on to best retain the coffee temperature. As soon as all the coffee has brewed, switch off and unplug the machine. If you haven't used the machine for a while, run one lot of water through it (without coffee) to clean it out. Never put the carafe in the microwave. Note ­ the backlight of the display will automatically turn off after 1 minute. 1 2 to program automatic brew Set the clock to the correct time (see `to set the clock'). Press the program button, the clock symbol and the display will flash. Press the clock button until the desired brewing time is displayed (follow procedure in `to set the clock'). Press the program button to return to the current time of day (the on/off button will continue to flash). The brewing cycle will begin once the set time is reached and the on/off button will stop flashing. If you want to check the automatic time selected, press the program button. To override the automatic brewing operation press the on/off button and the coffee maker will start immediately. Press the button again to switch off. carafe, lid, permanent filter, filter holder, water filter holder Wash, then dry. [. . . ] If required, press the program button once to change between the 12 and 24 hour clock. 3 To set the clock press the on/off button or wait 1 minute for it to automatically set. To re-adjust the clock at any time, press and hold the clock button for 5 seconds and adjust the clock as above. care & cleaning Always switch off, unplug and allow to cool before cleaning. water filter Change and discard the water filter after 70 brewing operations or within a calender month whichever is sooner. to descale 1 Buy a suitable descaler. [. . . ]