User manual KENWOOD DNX7160

[. . . ] 6 2 DNX SERIES    DFPKA$ properly, the front panel will automatically move into the position (initial setting angle) shown in (Fig. 2) After the Installation After the installation, perform the Initial Setup by referring to the instruction manual. ⤠• Mounting and wiring this product requires skills and experience. [. . . ] €¢ Reception may drop if there are metal objects near the Bluetooth antenna. Bluetooth antenna unit ¤ CAUTION Install this unit in the console of your vehicle. Do not touch the metal part of this unit during and shortly after the use of the unit. English 3    DFPKA$ Connection Ignition key switch ACC Ignition wire (Red) Battery wire (Yellow) Car fuse box (Main fuse) Car fuse box Antenna Cord Ground wire (Black) (To car chassis) ignition (red) and battery wire (yellow) ¤ If you connect the(ground), wire may causetheshort circuit, that in to the car chassis you a turn may start a fire. Always connect those wires to the power source running through the fuse box. a A FM/AM antenna input Battery Connect ⁄ detectionto the vehicle's parking brake switch harness. Parking sensor wire (Light Green) PRK SW For best safety, be sure to connect the parking sensor. Connect to vehicle's reverse lamp harness when using the optional rear view camera. To steering remote To use the steering wheel remote control feature, you need to an exclusive remote adapter (not supplied) matched to your car is required. „ To car light control switch Connect to the terminal that is grounded when either the telephone rings or during conversation. „ To connect the Kenwood navigation system, consult your navigation manual. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. When using the optional power amplifier, connect to its power control terminal. „ 4 DNX SERIES If no connections are made, do not let the cable come out from the tab.    DFPKA$ Bluetooth Microphone (Accessory #) (see page 8) Cooling fan GPS Antenna (Accessory !) (see page 8) FUSE ( 15A ) Accessory 1 Reverse sensor wire (Purple/White) REVERSE To front left speaker White/Black White + Steering remote control input (Light Blue/Yellow) REMOTE CONT STEERING WHEEL REMOTE INPUT To front right speaker Gray/Black Gray + Dimmer control wire (Orange/White) ILLUMI Mute control wire (Brown) MUTE To rear left speaker Green/Black Green + Motorized antenna control wire (Blue) ANT. [. . . ] Installation on Toyota, Nissan or Mitsubishi Car using Brackets Accessory 8 (M5x6mm) or Accessory 9 (M5x7mm) Car Bracket Accessory 8 (M5x6mm) or Accessory 9 (M5x7mm) 10 DNX SERIES    DFPKA$ Removing Monitor/Player Unit Removing the Hard Rubber Frame (escutcheon) 1. Engage the catch pins on the removal tool 5 and remove the two locks on the lower level. Remove the hard rubber frame by referring to the removal procedure in the section <Removing the Hard Rubber Frame>. [. . . ]